Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM (w/ Pre-collision System) › from 2022.09
RM25T0E _54 Brake _029873 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0548732 VEHICLE STABILITY CONTROL SYSTEM(w/ Pre-collision System) J

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM(w/ Pre-collision System)  Zero Point Calibration of Steering Angle Sensor Not Acquired (X20D8)  


DESCRIPTION

Code Tester Display Measurement Item Trouble Area
X20D8 Zero Point Calibration of Steering Angle Sensor Not Acquired History of being unable to obtain the steering angle zero point
·

Sensor installation

·

Yaw rate and acceleration sensor (airbag ECU assembly)



CAUTION / NOTICE / HINT

NOTICE:
·

This Vehicle Control History may be output during situations when the steering sensor zero point calibration temporarily cannot be acquired, such as when the stop light is stuck ON.

·

If the yaw rate and acceleration sensor (airbag ECU assembly) was replaced or reinstalled, perform "Calibration".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (w/ Pre-collision System)>CALIBRATION



PROCEDURE

1.CHECK FOR DTCs (HEALTH CHECK)
a.

Using the GTS, perform the Health Check.


Result:
Result Proceed to
DTCs are not output A
DTCs are output B



A

2.CHECK AIRBAG ECU ASSEMBLY INSTALLATION

B

GO TO DIAGNOSTIC TROUBLE CODE CHART

2.CHECK AIRBAG ECU ASSEMBLY INSTALLATION
a.

Check that the airbag ECU assembly has been installed properly.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>CENTER AIRBAG SENSOR ASSEMBLY>INSTALLATION

OK:

The sensor should be tightened to the specified torque.

The sensor is not installed in a tilted position.



Result:
Proceed to
OK
NG



OK

3.PERFORM ZERO POINT CALIBRATION OF STEERING SENSOR

NG

6.INSTALL AIRBAG ECU ASSEMBLY
3.PERFORM ZERO POINT CALIBRATION OF STEERING SENSOR
a.

Drive the vehicle straight ahead at 35 km/h (22 mph) or more for at least 5 seconds.

HINT:

When driving at a speed of 15 km/h or more for 1 second or more, the slip indicator light turns off.



Result:
Proceed to
NEXT



NEXT

4.CLEAR VEHICLE CONTROL HISTORY
4.CLEAR VEHICLE CONTROL HISTORY
a.

Using the GTS, clear the Vehicle Control History.

Chassis > Brake > Utility
Tester Display
Vehicle Control History (RoB)
50005 435 55

Result:
Proceed to
NEXT



NEXT

5.CHECK VEHICLE CONTROL HISTORY
5.CHECK VEHICLE CONTROL HISTORY
a.

Perform a road test under the same malfunction conditions recreated based on the Freeze Frame Data or customer problem analysis.


b.

Using the GTS, check for Vehicle Control History.

Chassis > Brake > Utility
Tester Display
Vehicle Control History (RoB)
50005 435 55

Result:
Result Proceed to
X20D8 is not output A
X20D8 is output B



A

END

B

6.INSTALL AIRBAG ECU ASSEMBLY

Result:
Proceed to
NEXT



NEXT

4.CLEAR VEHICLE CONTROL HISTORY