Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM (w/ Pre-collision System) › from 2022.09
RM25T0E _54 Brake _029873 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0548732 VEHICLE STABILITY CONTROL SYSTEM(w/ Pre-collision System) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM(w/ Pre-collision System)  C00631F  Yaw Rate Sensor Circuit Intermittent  C05201F  Multi-axis Acceleration Sensor Module "A" Circuit Intermittent  


DESCRIPTION

The airbag ECU assembly has a built-in yaw rate and acceleration sensor.

The skid control ECU (brake actuator assembly) receives signals from the yaw rate and acceleration sensor (airbag ECU assembly) via the CAN communication system.

DTC No. Detection Item DTC Detection Condition Trouble Area
C00631F Yaw Rate Sensor Circuit Intermittent When voltage at terminal +BS is 9.5 to 17.4 V, sensor invalid information received from yaw rate sensor is ON continuously for 10 seconds or more. Yaw rate sensor (Airbag ECU assembly)
C05201F Multi-axis Acceleration Sensor Module "A" Circuit Intermittent When voltage at terminal +BS is 9.5 to 17.4 V, sensor invalid information received from acceleration sensor is ON continuously for 10 seconds or more. Acceleration sensor (Airbag ECU assembly)

CAUTION / NOTICE / HINT

NOTICE:

If the yaw rate and acceleration sensor (airbag ECU assembly) was replaced or reinstalled, perform "Calibration".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (w/ Pre-collision System)>CALIBRATION


PROCEDURE

1.CHECK DTC
a.

Clear the DTCs.

Chassis > Brake > Clear DTCs
50002 435

b.

Turn the ignition switch off.


c.

Start the engine and idle it for 60 seconds, and then stop the engine.


d.

Check if the same DTC is recorded.

Chassis > Brake > Trouble Codes
50001 435

Result:
Proceed to
DTCs C00631F and/or C05201F are output
DTCs C00631F and C05201F are not output



DTCs C00631F and/or C05201F are output

DTCs C00631F and C05201F are not output