The skid control ECU (brake actuator assembly) is connected to the combination meter assembly via CAN communication.
After replacing the skid control ECU (brake actuator assembly), perform "Calibration".
Turn the ignition switch to ON.
Perform Active Test of the combination meter assembly using the GTS.
| Tester Display |
|---|
| Indicat. Lamp ABS |
Check the combination meter assembly.
The ABS warning light turns on or off in accordance with the GTS.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING