Home › Engine / Hybrid System › 1GR-FE (INTAKE / EXHAUST) › INTAKE MANIFOLD › from 2022.09
RM25T0E _51 Engine / Hybrid System _029771 1GR-FE INTAKE / EXHAUST _0135414 INTAKE MANIFOLD A

1GR-FE INTAKE / EXHAUST  INTAKE MANIFOLD  REMOVAL  


PROCEDURE

Hide 1. DISCHARGE FUEL SYSTEM PRESSURE

Hide 2. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 17705 5.REMOVE AIR CLEANER CAP SUB-ASSEMBLY WITH NO. 1 AIR CLEANER HOSE

a.
A331850

Detach the clamp and disconnect the mass air flow meter connector.


b.
A331851

Disconnect the vacuum hose from the No. 1 air cleaner hose.


c.

Slide the clamp and disconnect the No. 2 ventilation hose from the No. 1 air cleaner hose.


d.

Detach the clamp and disconnect the wire harness.


e.

Remove the bolt.


f.
A331852

Loosen the hose clamp and disconnect the No. 1 air cleaner hose from the cylinder head cover sub-assembly.


g.

Detach the 3 clamps and remove the air cleaner cap sub-assembly with No. 1 air cleaner hose.


Hide 17129 6.REMOVE INTAKE AIR SURGE TANK

a.
A151856

Disconnect the throttle body connector.


b.

Slide the clamp and disconnect the No. 4 water by-pass hose from the water inlet housing.


c.

Slide the clamp and disconnect the No. 5 water by-pass hose from the water inlet housing.


d.
A178934

Slide the clamp and disconnect the No. 1 fuel vapor feed hose from the No. 1 vacuum switching valve assembly.


e.

Disconnect the No. 1 vacuum switching valve connector.


f.

Slide the clamp and disconnect the No. 1 ventilation hose from the intake air surge tank.


g.
A218347

Disconnect the vacuum switching valve (for ACIS) connector.


h.
A151767

Remove the 2 bolts and throttle body bracket.


i.
A178935

Using a clip remover, detach the wire harness clamp from the No. 1 surge tank stay.


j.
A218319

Remove the bolt and disconnect the ground wire from the No. 1 surge tank stay.


k.

Remove the bolt and disconnect the engine oil level dipstick guide from the No. 1 surge tank stay.


l.

Remove the bolt and oil baffle plate.


m.

Remove the 2 bolts and No. 1 surge tank stay.


n.
A218333

Detach the wire harness clamp.


o.
A218328

Remove the 2 nuts and disconnect the clutch hose bracket.


p.

Remove the 2 bolts and No. 2 surge tank stay.


q.
A326469

Remove the 2 nuts.


r.

Using an 8 mm hexagon wrench, remove the 4 bolts. Then remove the intake air surge tank and gasket.


Hide 23801P 7.REMOVE NO. 1 FUEL PIPE SUB-ASSEMBLY

Hide 23802B 8.REMOVE NO. 2 FUEL PIPE SUB-ASSEMBLY

Hide 23807 9.REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY

Hide 17111 10.REMOVE INTAKE MANIFOLD

a.
A151776

Remove the 10 bolts, intake manifold and 2 gaskets.