Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING RECEIVER (for Semi-long Body) › from 2022.09
RM25T0E _53 Suspension _062777 TIRE PRESSURE MONITORING _0310954 TIRE PRESSURE WARNING RECEIVER(for Semi-long Body) A

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING RECEIVER(for Semi-long Body)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL TIRE PRESSURE WARNING ECU AND RECEIVER

a.

Connect the connector to the tire pressure warning ECU and receiver.


b.

Attach the 2 guides to temporarily install the tire pressure warning ECU and receiver.


c.

Install the bolt.

Torque:
8.5 N*m (87 kgf*cm, 75 in.*lbf)


Hide 62640P 2.INSTALL QUARTER TRIM PANEL ASSEMBLY LH

Hide 64707D 3.INSTALL QUARTER TRIM JACK COVER SUB-ASSEMBLY

Hide 6.INSTALL REAR NO. 2 SIDE SEAT ASSEMBLY LH

Hide 7.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 11. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART