When replacing an injector (including interchanging injectors between cylinders) or common rail, replace the corresponding injection pipes with new ones.
When fuel lines are disconnected, air may enter the fuel lines, leading to engine starting trouble. Therefore, perform forced regeneration and bleed the air from the fuel lines.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
3.DRAIN ENGINE COOLANT
17940D 4.REMOVE INTERCOOLER ASSEMBLY
5.REMOVE INJECTION PIPE
23706 6.REMOVE NO. 6 INJECTION PIPE SUB-ASSEMBLY
23810A 7.REMOVE COMMON RAIL ASSEMBLY RH
| *1 | Fuel Pressure Sensor |
| *a | Union Nut |
| *b | Fuel Pressure Sensor Connector |
| *c | Bolt |
Using a 17 mm union nut wrench, loosen the union nut and disconnect the No. 5 injection pipe sub-assembly.
Disconnect the fuel pressure sensor connector.
Remove the 2 bolts and common rail assembly RH.
Do not remove the fuel pressure sensor from the common rail assembly RH. If removed, replace the common rail assembly RH.
23802B 8.REMOVE NO. 2 FUEL PIPE SUB-ASSEMBLY
| *a | Clamp |
| *b | Union Bolt |
| *c | Bolt |
Slide the clamp and disconnect the fuel hose.
Remove the union bolt, gasket, bolt, and No. 2 fuel pipe sub-assembly.
23765 9.REMOVE NO. 5 NOZZLE LEAKAGE PIPE
| *1 | No. 5 Nozzle Leakage Pipe |
| *2 | No. 1 Fuel Hose |
| *a | Clamp |
| *b | Union Bolt |
Slide the clamp and disconnect the No. 1 fuel hose.
Remove the union bolt, gasket and No. 5 nozzle leakage pipe with No. 1 fuel hose.
23820A 10.REMOVE COMMON RAIL ASSEMBLY LH
| *1 | Pressure Discharge Valve |
Remove the 2 bolts and common rail assembly LH.
Do not remove the pressure discharge valve from the common rail assembly LH. If it is removed, replace the common rail assembly LH.