Home › Engine / Hybrid System › 1VD-FTV (FUEL) › COMMON RAIL (w/o DPF) › from 2022.09
RM25T0E _51 Engine / Hybrid System _029770 1VD-FTV FUEL _0135397 COMMON RAIL(w/o DPF) A

1VD-FTV FUEL  COMMON RAIL(w/o DPF)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 17940D 4.REMOVE INTERCOOLER ASSEMBLY

Hide 23706 6.REMOVE NO. 6 INJECTION PIPE SUB-ASSEMBLY

Hide 23820A 7.REMOVE COMMON RAIL RH

a.
A271422

Using a 17 mm union nut wrench, loosen the union nut and disconnect the No. 5 injection pipe sub-assembly.


b.

Disconnect the fuel pressure sensor connector.


c.

Remove the 2 bolts and common rail RH.

NOTICE:

Do not remove the fuel pressure sensor from the common rail RH. If removed, replace the common rail RH.



Hide 23239D 8.REMOVE NO. 1 FUEL HOSE

A163355

a.

Slide the 2 clamps and remove the No. 1 fuel hose from the No. 5 nozzle leakage pipe and No. 5 fuel pipe sub-assembly.


Hide 23765 9.REMOVE NO. 5 NOZZLE LEAKAGE PIPE

A163354

a.

Remove the union bolt, gasket and No. 5 nozzle leakage pipe from the common rail LH.


Hide 23810A 10.REMOVE COMMON RAIL LH

A163353

a.

Remove the 2 bolts and common rail LH.

NOTICE:

Do not remove the fuel pressure limiter from the common rail LH. If removed, replace the common rail LH.