Home › Engine / Hybrid System › 1GR-FE (FUEL) › FUEL SUB TANK (for Double Tank Type) › from 2022.09
RM25T0E _51 Engine / Hybrid System _029892 1GR-FE FUEL _0135865 FUEL SUB TANK(for Double Tank Type) A

1GR-FE FUEL  FUEL SUB TANK(for Double Tank Type)  INSTALLATION  


PROCEDURE

Hide 77011 1.INSTALL FUEL TANK FILLER LOWER PIPE SUB-ASSEMBLY

a.

Install a new gasket to the fuel tank filler lower pipe sub-assembly.


b.

Install the fuel tank filler lower pipe sub-assembly with the 6 screws to the fuel sub tank.


Hide 77203B 2.INSTALL FUEL SUCTION TUBE SUB-ASSEMBLY

a.

Install a new gasket to the fuel suction tube sub-assembly.


b.

Install the fuel suction tube sub-assembly with the 7 screws to the fuel sub tank.


c.

Install the nut.

Torque:
5.5 N*m (56 kgf*cm, 49 in.*lbf)


Hide 4.INSTALL FUEL SUB TANK

a.

Set the fuel sub tank and No. 1 fuel tank protector sub-assembly on an engine lifter.


b.

Raise the engine lifter.


c.

Install the 2 fuel tank bands with the 2 pins.


d.

Connect the 2 fuel tank bands with the 2 bolts.

Torque:
39 N*m (398 kgf*cm, 29 ft.*lbf)


e.

Connect the fuel pump connector and fuel sender gauge connector and attach the wire harness clamp.


Hide 77100D 5.CONNECT FUEL BREATHER HOSE

a.

Connect the fuel breather hose to the fuel sub tank and slide the clamp to secure the hose.


Hide 77213 6.CONNECT FUEL INLET HOSE

a.

Connect the fuel inlet hose to the fuel tank filler lower pipe sub-assembly and tighten the clamp to secure the hose.


Hide 7.CONNECT FUEL RETURN HOSE

a.

Connect the fuel return hose to the fuel suction tube sub-assembly and slide the clamp to secure the hose.


Hide 8.CONNECT FUEL MAIN HOSE

a.

Connect the fuel main hose to the fuel suction tube sub-assembly.

Click hereEngine / Hybrid System>1GR-FE (FUEL)>FUEL SYSTEM>PRECAUTION


Hide 9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 10. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART