52383E
1.REMOVE NO. 1 DIFFERENTIAL SUPPORT PROTECTOR
Click hereGeneral>MAINTENANCE>Q710 HYBRID TRANSAXLE FLUID>REPLACEMENT
52384C
2.REMOVE NO. 2 DIFFERENTIAL SUPPORT PROTECTOR
Click hereGeneral>MAINTENANCE>Q710 HYBRID TRANSAXLE FLUID>REPLACEMENT
53661B
3.REMOVE REAR SUSPENSION BRACE COVER
Click hereGeneral>MAINTENANCE>Q710 HYBRID TRANSAXLE FLUID>REPLACEMENT
4.INSPECT HYBRID TRANSAXLE FLUID
Pre-procedure1
| *a | 0 to 8 mm (0 to 0.315 in.) |
Using a 10 mm hexagon socket wrench, remove the filler plug and gasket from the FCV with motor transaxle assembly.
Procedure1
Check that the hybrid transaxle fluid level is between 0 to 8 mm (0 to 0.315 in.) from the bottom lip of the filler plug opening.
When inspecting the hybrid transaxle fluid, make sure that the vehicle is level.
Be sure to directly check that the hybrid transaxle fluid level is within the specified range.
Driving the vehicle with an insufficient or excessive amount of hybrid transaxle fluid may damage the FCV with motor transaxle assembly.
If the hybrid transaxle fluid was replaced or if hybrid transaxle fluid was added, make sure to recheck the hybrid transaxle fluid level after driving the vehicle.
Post-procedure1
Check for leaks if the hybrid transaxle fluid level is low. (If there are no hybrid transaxle fluid leaks but the hybrid transaxle fluid level is low, add hybrid transaxle fluid.)
Using a 10 mm hexagon socket wrench, install the filler plug and a new gasket to the FCV with motor transaxle assembly.
5.INSPECT FOR HYBRID TRANSAXLE FLUID LEAK
Click hereGeneral>MAINTENANCE>Q710 HYBRID TRANSAXLE FLUID>REPLACEMENT
53661B
6.INSTALL REAR SUSPENSION BRACE COVER
Click hereGeneral>MAINTENANCE>Q710 HYBRID TRANSAXLE FLUID>REPLACEMENT
52384C
7.INSTALL NO. 2 DIFFERENTIAL SUPPORT PROTECTOR
Click hereGeneral>MAINTENANCE>Q710 HYBRID TRANSAXLE FLUID>REPLACEMENT
52383E
8.INSTALL NO. 1 DIFFERENTIAL SUPPORT PROTECTOR
Click hereGeneral>MAINTENANCE>Q710 HYBRID TRANSAXLE FLUID>REPLACEMENT