| *A | w/o Telematics Transceiver | - | - |
| *1 | NAVIGATION ANTENNA BRACKET | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the navigation antenna assembly removal/installation are shown below.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
| Effect/Inoperative Function When Necessary Procedures are not Performed | Necessary Procedures | Link |
|---|---|---|
| Air conditioning system | After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. | - |
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1. PRECAUTION
2.REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY
3.REMOVE NAVIGATION ANTENNA ASSEMBLY WITH BRACKET
86860
4.REMOVE NAVIGATION ANTENNA ASSEMBLY
|
Remove in this Direction | - | - |
86101M
5.REMOVE ANTENNA CORD SUB-ASSEMBLY (w/o Telematics Transceiver)