| *1 | TELEMATICS TRANSCEIVER | *2 | INTEGRATION CONTROL SUB-ASSEMBLY |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the integration control sub-assembly removal/installation are shown below.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
| Effect/Inoperative Function When Necessary Procedures are not Performed | Necessary Procedures | Link |
|---|---|---|
| Air conditioning system | After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. | - |
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1. PRECAUTION
55403E
2.REMOVE NO. 2 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
3.REMOVE NAVIGATION ECU ASSEMBLY WITH BRACKET
4.REMOVE TELEMATICS TRANSCEIVER WITH BRACKET
84113H
5.REMOVE NO. 1 INTEGRATION CONTROL BRACKET
84113J
6.REMOVE NO. 2 INTEGRATION CONTROL BRACKET