| *A | w/ Navigation System | *B | w/o Navigation System |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the instrument panel passenger without door airbag assembly removal/installation are shown below.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
| Effect/Inoperative Function When Necessary Procedures are not Performed | Necessary Procedures | Link |
|---|---|---|
| Air conditioning system | After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. | - |
1. PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
|
|
3.REMOVE MULTI-DISPLAY ASSEMBLY WITH BRACKET (w/ Navigation System)
4.REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (w/o Navigation System)
55550
5.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY
55403E
6.REMOVE NO. 2 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
Detach the clamp.
Disconnect the airbag connector.
Refer to How to Connect or Disconnect Airbag Connector:
Remove the 2 bolts.
|
Remove in this Direction | - | - |
Remove the 4 screws.
Detach the clip and remove the No. 2 instrument panel safety pad sub-assembly as shown in the illustration.
73960A
7.REMOVE INSTRUMENT PANEL PASSENGER WITHOUT DOOR AIRBAG ASSEMBLY
|
|
Remove the 2 screws.
Lean the instrument panel safety pad sub-assembly and detach the hook.
Detach the hook to remove the instrument panel passenger without door airbag assembly from the No. 2 instrument panel safety pad sub-assembly.