Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CURTAIN SHIELD AIRBAG ASSEMBLY
RM37H0E _58 Vehicle Interior _095287 SUPPLEMENTAL RESTRAINT SYSTEMS _0448070 CURTAIN SHIELD AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  CURTAIN SHIELD AIRBAG ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
B605588N02
2.875,2.094 3.917,2.573 1.042,0.479 6.906,0.146 6.521,0.146 false 6.865,0.573 6.531,0.573 false 4.531,0.333 4.156,0.333 4.156,0.333 3.833,0.698 true 5.719,2.208 5.167,1.677 5.167,1.677 4.76,1.677 true 3.365,2.24 3.167,2.24 3.167,2.24 3.063,2.438 false 3.385,1.813 3.052,2.094 false 5,3.396 4.646,3.396 4.646,3.396 4.469,3.156 false 2.333,2.552 2.052,2.552 false 2.927,2.781 2.865,2.885 2.865,2.885 2.594,2.885 false 2.177,3.198 1.792,3.198 false 6.313,0.042 6.5,0.344 0.188,0.302 18 false 1 6.333,0.458 6.521,0.76 0.188,0.302 18 false 2 4.604,0.208 4.792,0.51 0.188,0.302 18 false 3 4.25,1.573 4.438,1.875 0.188,0.302 18 false 4 2.406,3.073 2.667,3.24 0.26,0.167 10 false x 6 2.458,2.365 2.792,2.552 0.333,0.188 10 false x 3 1.927,2.458 2.188,2.625 0.26,0.167 10 false ● 3.448,1.698 3.865,1.927 0.417,0.229 10 false ●*1 1.646,3.104 1.906,3.271 0.26,0.167 10 false ● 3.188,2.583 3.448,2.75 0.26,0.167 10 false x 3 3.427,2.156 3.688,2.323 0.26,0.167 10 false *2 5.083,3.292 5.438,3.531 0.354,0.24 10 false ●*3 2.354,2.792 2.635,2.979 0.281,0.188 10 false ●*2

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION - (Click here) - -
2 DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL - (Click here) - -
3 ROOF HEADLINING ASSEMBLY 63310 - - -
4 CURTAIN SHIELD AIRBAG ASSEMBLY LH 62180A (Click here) - -

*1 ROOF SIDE INNER GARNISH CLIP *2 PIN
*3 SPACER - -
● Non-reusable part - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the curtain shield airbag assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Memorize steering angle neutral point Panoramic View Monitor System (Click here)

HINT:

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Adaptive high beam system

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Air conditioning system After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. -



PROCEDURE

Hide 1. PRECAUTION

Z101186

CAUTION:
B475753

Be sure to read precaution thoroughly before servicing.

Click here(Click here)


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

Click here(Click here)



Hide 2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Z101186

CAUTION:
B422343

·

Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.




Click hereGeneral>MAINTENANCE>AUXILIARY BATTERY>REMOVAL

Hide 63310 3.REMOVE ROOF HEADLINING ASSEMBLY

Hide 62180A 4.REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH

Z101186

CAUTION:
B399183

·

When storing the curtain shield airbag assembly LH, keep the airbag deployment side facing upward.

·

If the airbag deploys for any reason, it may cause a serious accident.




a.
B605562C01
1.042,0.458 1.833,0.458 true 0.458,0.104 0.74,0.458 0.281,0.354 18 false i 4.49,0.156 4.771,0.51 0.281,0.354 18 false ii 0.813,0.375 1.042,0.604 0.229,0.229 10 true *a
*a Turns off - -


i.

Check that the ignition switch is off.


ii.

Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:
·

Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.





b.
B607248N01
2.542,0.104 2.729,0.396 0.188,0.292 18 true i

i.

Disconnect the airbag connector.

HINT:

Refer to How to Connect or Disconnect Airbag Connector:

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR




c.
B605592C01
5.906,1 5.99,0.781 5.99,0.781 6.271,0.781 true 4.198,0.5 4.354,0.219 4.354,0.219 4.552,0.219 true 2.802,2.323 3.073,2.323 false 5.385,1.854 4.917,2.167 4.917,2.167 5.635,1.958 true 2.115,0.615 1.969,0.375 1.969,0.375 1.802,0.375 true 2.844,1.844 3.115,1.844 false 5.177,0.729 5.344,0.49 5.344,0.49 5.583,0.49 true 1.781,1.865 2.052,1.865 false 6.281,0.667 6.5,0.833 0.219,0.167 10 true *1 4.583,0.125 4.802,0.281 0.219,0.156 10 true *2 3.104,2.229 3.417,2.385 0.313,0.156 10 false *a 4.698,2.083 5.01,2.24 0.313,0.156 10 false *c 3.146,1.771 3.458,1.927 0.313,0.156 10 false *b 5.625,0.396 5.844,0.563 0.219,0.167 10 true *1 6.844,0.969 7.094,1.24 0.25,0.271 18 true iii 0.427,3.552 0.719,3.896 0.292,0.344 18 true iv 1.083,1.74 1.417,2.073 0.333,0.333 18 false i 4.75,1.729 4.979,2.021 0.229,0.292 18 false ii 2.625,0 2.875,0.25 0.25,0.25 18 true iii 3.042,0.01 3.323,0.26 0.281,0.25 18 true iii 1.563,0.292 1.781,0.458 0.219,0.167 10 true *1 2.094,1.781 2.406,1.938 0.313,0.156 10 false *b 1.333,1.167 1.563,1.448 0.229,0.281 18 true iii 0.688,0.156 0.896,0.427 0.208,0.271 18 true iii 3.74,1.156 3.979,1.406 0.24,0.25 18 true iii
*1 Clip *2 Roof Side Inner Garnish Clip
*a Pin *b Needle-Nose Pliers No. 2
*c Thin-Bladed Screwdriver - -
V113147

Remove in this Direction - -


i.

Using needle nose pliers No. 2, remove the pin from the clip and roof side inner garnish clip.

HINT:

Use the same procedure for the opposite side.



ii.

Using 2 thin-bladed screwdrivers, detach the claw and remove the 3 clips and roof side inner garnish clip together with the curtain shield airbag assembly LH deployment portion.


iii.

Remove the 6 bolts.


iv.

While holding the curtain shield airbag assembly LH, detach the clip and the hook to remove it.



d.
B607251C01
1.521,1.188 1.521,0.979 false 0.125,0.073 0.406,0.427 0.281,0.354 18 false i 2.948,0.396 3.26,0.594 0.313,0.198 10 false *2 4.677,0.313 4.99,0.51 0.313,0.198 10 false *1 6.26,0.76 6.573,0.958 0.313,0.198 10 false *2 5.563,0.5 5.875,0.698 0.313,0.198 10 false *2 1.448,1.229 1.76,1.427 0.313,0.198 10 false *a
*1 Roof Side Inner Garnish Clip *2 Clip
*a Spacer - -


i.

Remove the 3 clips, roof side inner garnish clip and spacer from the front side of the curtain shield airbag assembly LH.