| *A | for Driver Side | - | - |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) | - | - |
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
89860A
1.INSTALL SIDE AIRBAG SENSOR ASSEMBLY LH
| *a | Turns off | - | - |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
Attach the guide to hold the side airbag sensor assembly LH in place.
If the side airbag sensor assembly LH has been dropped, replace it with a new one.
Install the bolt.
If the side airbag sensor assembly LH has been dropped, replace it with a new one.
When installing the side airbag sensor assembly LH, be careful that the SRS wiring does not interfere with or is not pinched between other parts.
Tighten the bolt while holding the side airbag sensor assembly LH because the side airbag sensor assembly LH guide is easily damaged.
Check that there is no looseness in the installation parts of the side airbag sensor assembly LH.
Connect the airbag connector.
When connecting any airbag connector, take care not to damage the airbag wire harness.
Refer to How to Connect or Disconnect Airbag Connector.
58510C
2.INSTALL FRONT FLOOR CARPET ASSEMBLY FRONT
58521C
3.INSTALL NO. 2 FLOOR CARPET HOOK
87212J
4.INSTALL REAR NO. 5 AIR DUCT
87217B
5.INSTALL AIR DUCT PLUG
78010F
6.INSTALL ACCELERATOR PEDAL ASSEMBLY
78118
7.INSTALL ACCELERATOR PEDAL PAD
62414A
8.INSTALL LOWER CENTER PILLAR GARNISH LH
67918F
11.INSTALL REAR DOOR SCUFF PLATE INSIDE LH
67914B
12.INSTALL FRONT DOOR SCUFF PLATE LH
13.INSTALL FRONT SEAT ASSEMBLY LH
14. PERFORM DIAGNOSTIC SYSTEM CHECK
15.CHECK SRS WARNING LIGHT