Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT FLOOR AIRBAG SENSOR
RM37H0E _58 Vehicle Interior _095287 SUPPLEMENTAL RESTRAINT SYSTEMS _0448075 FRONT FLOOR AIRBAG SENSOR A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT FLOOR AIRBAG SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
B605615N01
6.49,0.188 6.875,0.188 false 3.99,0.708 4.573,0.708 true 0.625,1.313 1.01,1.313 true 3.188,2.156 3.417,1.875 3.417,1.875 3.813,1.875 true 5.01,3.458 5.01,3.063 5.01,3.063 5.188,3.063 true 3.76,2.813 4.042,2.813 true 2.188,1.958 2.563,1.958 true 6.281,0.063 6.563,0.417 0.281,0.354 18 false 1 4.656,0.573 4.938,0.927 0.281,0.354 18 false 2 5.281,2.938 5.563,3.292 0.281,0.354 18 false 4 1.094,1.177 1.375,1.531 0.281,0.354 18 false 3 1.677,1.823 1.958,2.177 0.281,0.354 18 false 5 4.427,2.719 4.708,3.073 0.281,0.354 18 false 6 3.875,1.75 4.156,2.104 0.281,0.354 18 false 7

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION - (Click here) - -
2 FRONT SEAT ASSEMBLY LH - - - -
3 FRONT DOOR SCUFF PLATE LH 67914B - - -
4 REAR DOOR SCUFF PLATE INSIDE LH 67918F - - -
5 FRONT DOOR OPENING TRIM WEATHERSTRIP LH 62312B (Click here) - -
6 REAR DOOR OPENING TRIM WEATHERSTRIP LH 62332A (Click here) - -
7 LOWER CENTER PILLAR GARNISH LH 62414A - - -

B605616N01
2.771,1.354 3.604,2.073 0.833,0.719 0.094,0.146 1.969,2.125 1.875,1.979 1.073,0.625 1.354,0.625 true 0.76,1.896 1.094,1.896 true 3.771,2.708 4.417,2.708 false 3.365,3.469 3.552,3.469 false 3.354,4.469 3.635,4.469 false 1.208,3.385 1.667,3.385 false 2.646,1.781 2.771,1.781 false 0.896,0.51 1.177,0.865 0.281,0.354 18 false 8 0.563,1.792 0.844,2.146 0.281,0.354 18 false 9 3.865,3.313 4.417,3.698 0.552,0.385 18 false 10 3.698,4.302 4.521,4.656 0.823,0.354 18 false 11 3.427,2.583 4.26,2.99 0.833,0.406 18 false 13 1.74,1.333 2.052,1.531 0.313,0.198 10 false x 2 5.646,2.646 5.958,2.844 0.313,0.198 10 false x2 3.427,3.896 3.74,4.094 0.313,0.198 10 false x 2 2.344,1.635 2.927,1.99 0.583,0.354 18 false 12 0.583,3.25 1.26,3.604 0.677,0.354 18 false 14 0.156,0.24 0.458,0.542 0.302,0.302 12 false *A 3.01,3.417 3.469,3.615 0.458,0.198 10 false x 2

Procedure Part Name Code
Z101186

Z101188

Z101187

8 ACCELERATOR PEDAL PAD 78118 - - -
9 ACCELERATOR PEDAL ASSEMBLY 78010F (Click here) - -
10 AIR DUCT PLUG 87217B (Click here) - -
11 REAR NO. 5 AIR DUCT 87212J - - -
12 NO. 2 FLOOR CARPET HOOK 58521C (Click here) - -
13 FRONT FLOOR CARPET ASSEMBLY FRONT 58510C - - -
14 SIDE AIRBAG SENSOR ASSEMBLY LH 89860A (Click here) - -

*A for Driver Side - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the side airbag sensor assembly removal/installation are shown below.

Necessary Procedures after parts removed/installed/replaced
Replacement Part or Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Disconnect cable from negative (-) auxiliary battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic View Monitor System (Click here)

HINT:

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Adaptive high beam system

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Air conditioning system After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. -



PROCEDURE

Hide 1. PRECAUTION

Z101186

CAUTION:
B475753

Be sure to read precaution thoroughly before servicing.

Click here(Click here)


NOTICE:

After the ignition switch is turned off, there may be a waiting time before disconnecting the auxiliary negative (-) battery terminal.

Click here(Click here)



Hide 2.REMOVE FRONT SEAT ASSEMBLY LH

Hide 67914B 3.REMOVE FRONT DOOR SCUFF PLATE LH

a.

Use the same procedure described for the RH side.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX>REMOVAL


Hide 67918F 4.REMOVE REAR DOOR SCUFF PLATE INSIDE LH

Hide 62312B 5.REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH

Z101186

HINT:

Remove the rear side of the front door opening trim weatherstrip LH so that the lower center pillar garnish LH can be removed.

Click here(Click here)



Hide 62332A 6.REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH

Z101186

HINT:

Remove the front side of the rear door opening trim weatherstrip LH so that the lower center pillar garnish LH can be removed.

Click here(Click here)



Hide 62414A 7.REMOVE LOWER CENTER PILLAR GARNISH LH

Hide 78010F 9.REMOVE ACCELERATOR PEDAL ASSEMBLY

Z101186

Click here(Click here)

Hide 87217B 10.REMOVE AIR DUCT PLUG

Z101186

Click here(Click here)

Hide 58521C 12.REMOVE NO. 2 FLOOR CARPET HOOK

Z101186

Click here(Click here)

Hide 58510C 13.REMOVE FRONT FLOOR CARPET ASSEMBLY FRONT

a.
B605617C01
0.979,1.844 1.115,2.167 0.135,0.323 18 true i 4.49,2.094 4.677,2.406 0.188,0.313 18 true ii 2.292,1.979 2.5,2.292 0.208,0.313 18 true iii
V113147

Fold Back - -


i.

Detach the claw.


ii.

Detach the fastener.


iii.

Fold back the front floor carpet assembly front and hold it.



Hide 89860A 14.REMOVE SIDE AIRBAG SENSOR ASSEMBLY LH

a.
B605562C01
1.042,0.458 1.833,0.458 true 0.458,0.104 0.74,0.458 0.281,0.354 18 false i 4.49,0.156 4.771,0.51 0.281,0.354 18 false ii 0.813,0.375 1.042,0.604 0.229,0.229 10 true *a
*a Turns off - -


i.

Check that the ignition switch is off.


ii.

Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:
·

Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.





b.
B605618N01
0.927,0.125 1.104,0.417 0.177,0.292 18 true i 4.417,0.115 4.917,0.406 0.5,0.292 18 true ii, iii

i.

Disconnect the airbag connector.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.


HINT:

Refer to How to Connect or Disconnect Airbag Connector

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR



ii.

Remove the bolt.

NOTICE:
·

Loosen the bolt while holding the side airbag sensor because the side airbag sensor guide is easily damaged.

·

If the side airbag sensor has been dropped, replace it with a new one.




iii.

Detach the guide and remove the side airbag sensor assembly LH.