Home › Audio / Visual / Telematics › AUDIO / VIDEO › ASC SPEAKER (for Instrument Panel)
RM37H0E _56 Audio / Visual / Telematics _095260 AUDIO / VIDEO _0448074 ASC SPEAKER(for Instrument Panel) A

AUDIO / VIDEO  ASC SPEAKER(for Instrument Panel)  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
E455464N03
2.354,0.688 2.917,0.688 false 5.021,2.104 5.396,3.01 5.396,3.01 5.885,3.01 false 6.552,0.188 6.813,0.188 false 6.375,0.052 6.531,0.385 0.156,0.333 18 false 1 5.958,2.833 6.24,3.188 0.281,0.354 18 false 2 2.99,0.542 3.271,0.896 0.281,0.354 18 false 3 1.979,0.365 2.292,0.563 0.313,0.198 10 false x 2

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION - (Click here) - -
2 INSTRUMENT PANEL SAFETY PAD ASSEMBLY - - - -
3 NO. 2 SPEAKER WITH BOX ASSEMBLY 86150B - - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the No. 2 speaker with box assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary procedures Effect/Inoperative Function when Necessary Procedure are not Performed Link
Disconnect cable from negative (-) auxiliary battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (Click here)

HINT:
·

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Adaptive high beam system

-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Air conditioning system After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. -


·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

Z101186

CAUTION:
B475753

Be sure to read precaution thoroughly before servicing.

Click here(Click here)


NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

Click here(Click here)



Hide 2.REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY

Hide 86150B 3.REMOVE NO. 2 SPEAKER WITH BOX ASSEMBLY

a.
E455465