| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | SEATBACK HEATER ASSEMBLY RH | 87510R | ( )
|
- | - |
| 2 | SEATBACK HEATER ASSEMBLY LH | 87510S | ( )
|
- | - |
| 3 | BENCH TYPE REAR SEATBACK COVER | 71077B | ( )
|
- | - |
| *1 | REAR SEATBACK PAD SUB-ASSEMBLY | - | - |
| ● | Non-reusable part | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 4 | HEADREST SUPPORT | - | - | - | - |
| 5 | REAR CENTER SEAT ARMREST ASSEMBLY | 72830 | - | - | - |
| 6 | REAR CENTER SEAT HEADREST ASSEMBLY | 71960B | - | - | - |
| 7 | REAR SEAT HEADREST ASSEMBLY | 71940A | - | - | - |
|
N*m (kgf*cm, ft.*lbf) : Specified torque | - | - |
| *A | w/ Climate Control Seat System | - | - |
| *1 | REAR SEAT OUTER BELT ASSEMBLY LH (FLOOR ANCHOR) | *2 | REAR SEAT OUTER BELT ASSEMBLY RH (FLOOR ANCHOR) |
| *3 | REAR SEAT INNER WITH CENTER BELT ASSEMBLY RH (FLOOR ANCHOR) | - | - |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) | ● | Non-reusable part |
Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
Move both front seats to the frontmost position and fold them forward.
87510R
1.INSTALL SEATBACK HEATER ASSEMBLY RH
| *a | A Area | *b | B Area |
| *c | C Area | *d | Bridge Area |
| *e | Matchmark | - | - |
Follow the steps below to install the seatback heater assembly RH to the rear seatback pad sub-assembly.
1. Remove the peeling paper on the A area and attach the A area of the seatback heater assembly RH to the rear seatback pad sub-assembly aligning with the matchmark.
2. Remove the peeling paper on the B area and attach the B area of the seatback heater assembly RH to the rear seatback pad sub-assembly aligning with the matchmark.
3. Remove the peeling paper on the C area and attach the C area of the seatback heater assembly RH to the rear seatback pad sub-assembly aligning with the matchmark.
4. Insert the bridge area to the groove of rear seatback pad sub-assembly.
After removing the peeling paper, do not touch the surface of the tape with your fingers or cotton work gloves.
Do not reuse the seatback heater assembly RH and rear seatback pad sub-assembly.
Apply pressure to paste the seatback heater assembly RH to the rear seatback pad sub-assembly securely.
87510S
2.INSTALL SEATBACK HEATER ASSEMBLY LH
Use the same procedure described for the RH side.
4.INSTALL HEADREST SUPPORT
72830
5.INSTALL REAR CENTER SEAT ARMREST ASSEMBLY
71960B
6.INSTALL REAR CENTER SEAT HEADREST ASSEMBLY
71940A
7.INSTALL REAR SEAT HEADREST ASSEMBLY
71398A
8.INSTALL REAR SEATBACK HOLDER
72693
10.INSTALL REAR SEAT CUSHION LOCK HOOK