| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | SEAT CUSHION HEATER ASSEMBLY RH | 87510P | ( )
|
- | - |
| 2 | SEAT CUSHION HEATER ASSEMBLY LH | 87510Q | ( )
|
- | - |
| 3 | BENCH TYPE REAR SEAT CUSHION COVER | 71075B | ( )
|
- | - |
| *1 | REAR SEAT CUSHION PAD SUB-ASSEMBLY | - | - |
| ● | Non-reusable part | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 4 | REAR SEAT CUSHION LOCK HOOK | 72693 | - | - | - |
| 5 | BENCH TYPE REAR SEAT CUSHION ASSEMBLY | - | ( )
|
- | - |
| 6 | INSPECT SEAT HEATER SYSTEM | - | ( )
|
- | - |
| ● | Non-reusable part | - | - |
Move both front seats to the frontmost position and fold them forward.
87510P
1.INSTALL SEAT CUSHION HEATER ASSEMBLY RH
| *a | A Area | *b | B Area |
| *c | C Area | *d | D Area |
| *e | E Area | *f | Bridge Area |
| *g | Matchmark | - | - |
Follow the steps below to install the seat cushion heater assembly RH to the rear seat cushion pad sub-assembly.
1. Remove the peeling paper on the A area and attach the A area of the seat cushion heater assembly RH to the rear seat cushion pad sub-assembly aligning with the matchmark.
2. Remove the peeling paper on the B area and attach the B area of the seat cushion heater assembly RH to the rear seat cushion pad sub-assembly aligning with the matchmark.
3. Remove the peeling paper on the C area and attach the C area of the seat cushion heater assembly RH to the rear seat cushion pad sub-assembly aligning with the matchmark.
4. Remove the peeling paper on the D area and attach the D area of the seat cushion heater assembly RH to the rear seat cushion pad sub-assembly aligning with the matchmark.
5. Remove the peeling paper on the E area and attach the E area of the seat cushion heater assembly RH to the rear seat cushion pad sub-assembly aligning with the matchmark.
6. Insert the bridge area to the groove of rear seat cushion pad sub-assembly.
After removing the peeling paper, do not touch the surface of the tape with your fingers or cotton work gloves.
Do not reuse the seat cushion heater assembly RH and rear seat cushion pad sub-assembly.
Apply pressure to paste the seat cushion heater assembly RH to the rear seat cushion pad sub-assembly securely.
87510Q
2.INSTALL SEAT CUSHION HEATER ASSEMBLY LH
Use the same procedure described for the RH side.
72693
4.INSTALL REAR SEAT CUSHION LOCK HOOK