Home › Vehicle Interior › LIGHTING (INT) › ILLUMINATION ECU (for Front Side)
RM37H0E _58 Vehicle Interior _095306 LIGHTING (INT) _0448225 ILLUMINATION ECU(for Front Side) A

LIGHTING (INT)  ILLUMINATION ECU(for Front Side)  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
E457753N01
6.604,0.229 6.833,0.229 false 4.646,1.313 4.844,0.99 4.844,0.99 5,0.99 false 3.823,0.729 4.104,0.729 false 6.406,0.073 6.688,0.427 0.281,0.354 18 false 1 5.052,0.844 5.333,1.198 0.281,0.354 18 false 2 3.625,0.583 3.906,0.938 0.281,0.354 18 false 3

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION - (Click here) - -
2 INSTRUMENT PANEL SAFETY PAD - - - -
3 ROOM LIGHT CONTROL RELAY 85965 - - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during room light control relay removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (Click here)

HINT:
·

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane Tracing Assist System Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision System
Adaptive high beam system

-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -


·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

Z101186

CAUTION:
B475753

Be sure to read precaution thoroughly before servicing.

Click here(Click here)


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

Click here(Click here)



Hide 85965 3.REMOVE ROOM LIGHT CONTROL RELAY

a.
E454192