| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | METER MIRROR SUB-ASSEMBLY | 83108 | ( )
|
- | - |
| 2 | INSTRUMENT PANEL SAFETY PAD ASSEMBLY | - | - | - | - |
| 3 | INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL | - | - | - | ( )
|
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
83108
1.INSTALL METER MIRROR SUB-ASSEMBLY
Connect the connector.
Temporarily install the meter mirror sub-assembly with the 4 bolts.
Tighten the 4 bolts in the order shown in the illustration, install the meter mirror sub-assembly.
2.INSTALL INSTRUMENT PANEL SAFETY PAD ASSEMBLY
3. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART