Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SIDE AIRBAG SENSOR
RM37H0E _58 Vehicle Interior _095287 SUPPLEMENTAL RESTRAINT SYSTEMS _0448370 SIDE AIRBAG SENSOR A

SUPPLEMENTAL RESTRAINT SYSTEMS  SIDE AIRBAG SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

COMPONENTS (INSTALLATION)
B605609N01
0.365,0.406 3.375,1.74 3.01,1.333 3.271,2.708 4.271,2.875 1,0.167 3.219,2.667 4.302,2.917 1.083,0.25 1.823,1.729 1.823,0.406 false 2.333,1.583 2.719,1.583 2.719,1.583 2.875,1.167 true 0.729,1.573 1.083,1.573 1.083,1.573 1.271,1.219 true 3.563,3.604 3.281,3.604 3.281,3.604 3.031,3.219 true 3.156,4.229 2.302,4.229 true 1.521,2.188 1.198,2.188 true 6.854,0.208 6.5,0.208 false 6.823,0.594 6.5,0.594 false 4.115,2.198 4.01,1.906 4.01,1.906 3.823,1.906 true 6.813,0.948 6.49,0.948 false 3.625,2.469 3.625,2.667 false 0.802,2.531 1.115,2.729 0.313,0.198 10 false x 2 2.094,2.771 2.406,2.969 0.313,0.198 10 false x 3 0.438,0.469 0.75,0.667 0.313,0.198 12 false *A 1.896,0.458 2.208,0.656 0.313,0.198 12 false *B 5.854,0.052 6.781,0.365 0.927,0.313 18 false 10,11 1.031,2.063 1.313,2.417 0.281,0.354 18 false 6 2.146,1.469 2.427,1.823 0.281,0.354 18 false 5 0.469,1.427 0.75,1.781 0.281,0.354 18 false 4 3.229,4.104 3.51,4.458 0.281,0.354 18 false 3 3.646,3.469 3.927,3.823 0.281,0.354 18 false 2 3.396,1.781 3.677,2.135 0.281,0.354 18 false 1 6.125,0.823 6.625,1.177 0.5,0.354 18 false 8,9 3.344,2.729 4.552,2.906 1.208,0.177 8 false 9.0 (92, 80 in.*lbf) 6.323,0.458 6.844,0.771 0.521,0.313 18 false 7

Procedure Part Name Code
Z101186

Z101188

Z101187

1 SIDE AIRBAG PRESSURE SENSOR ASSEMBLY LH 8983AA (Click here) - -
2 FRONT DOOR SERVICE HOLE COVER LH 67832 - - -
3 FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH 67602 - - -
4 MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL - - - -
5 POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL - - - -
6 FRONT DOOR INSIDE HANDLE BEZEL PLUG LH 69284C - - -
7 NEGATIVE AUXILIARY BATTERY TERMINAL - (Click here) - -
8 INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL - - - (Click here)
9 PERFORM DIAGNOSTIC SYSTEM CHECK - - - (Click here)
10 CHECK POWER WINDOW OPERATION - (Click here) - -
11 CHECK SRS WARNING LIGHT - (Click here) - -

*A for Driver Side *B for Front Passenger Side
V111893

Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) - -

CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 8983AA 1.INSTALL SIDE AIRBAG PRESSURE SENSOR ASSEMBLY LH

a.
B605562C01
1.042,0.458 1.833,0.458 true 0.458,0.104 0.74,0.458 0.281,0.354 18 false i 4.49,0.156 4.771,0.51 0.281,0.354 18 false ii 0.813,0.375 1.042,0.604 0.229,0.229 10 true *a
*a Turns off - -


i.

Check that the ignition switch is off.


ii.

Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:
·

Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.





b.
B605610N01
6.104,1.125 6.302,1.406 0.198,0.281 18 true i 1.906,0.333 2.115,0.625 0.208,0.292 18 true ii 1.771,1.417 1.99,1.708 0.219,0.292 18 true iii 2.5,2.052 2.781,2.406 0.281,0.354 18 true iv

i.

Connect the airbag connector.

NOTICE:

When connecting any airbag connector, take care not to damage the airbag wire harness.


HINT:

Refer to How to Connect or Disconnect Airbag Connector:

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR



ii.

Attach the claw to hold the side airbag pressure sensor assembly LH in place.


iii.

Install side airbag pressure sensor assembly LH with the nut.

Torque:
9.0 N*m (92 kgf*cm, 80 in.*lbf)

NOTICE:
·

If the side airbag pressure sensor assembly LH has been dropped, replace it with a new one.

·

When installing the side airbag pressure sensor assembly LH, be careful that the SRS wiring does not interfere with or is not pinched between other parts.




iv.

Check that there is no looseness in the installation parts of the side airbag pressure sensor assembly LH.



Hide 67832 2.INSTALL FRONT DOOR SERVICE HOLE COVER LH

Hide 67602 3.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 4.INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)

Hide 5.INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

Hide 69284C 6.INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

Hide 7.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 8. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART


Hide 9. PERFORM DIAGNOSTIC SYSTEM CHECK