Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM
RM37H0E _58 Vehicle Interior _095306 LIGHTING (INT) _0448415 LIGHTING SYSTEM J

LIGHTING (INT)  LIGHTING SYSTEM  Luggage Compartment Door Courtesy Switch Circuit  


DESCRIPTION

The main body ECU (multiplex network body ECU) detects the condition of the luggage compartment door lock assembly (luggage compartment door courtesy light switch).

WIRING DIAGRAM

E462980E01
5.677,1.781 6.292,1.979 0.615,0.198 10 false LGCY 5.427,2.375 6.042,2.573 0.615,0.198 10 false A 5.417,2.573 7.083,3.24 1.667,0.667 10 false Main Body ECU (Multiplex Network Body ECU) 4.094,2.552 5.323,2.958 1.229,0.406 10 false Driver Side Junction Block Assembly 4.115,2.385 5.375,2.906 1.26,0.521 10 false 4H 4.146,1.5 5.135,2.021 0.99,0.521 10 false 27 5.385,1.49 6.375,2.01 0.99,0.521 10 false 4 3.531,1.521 4.521,2.042 0.99,0.521 10 false 3 0.875,1.51 1.865,2.031 0.99,0.521 10 false 2 1.177,2.344 3.594,2.604 2.417,0.26 10 false K1 1.167,2.51 2.938,2.875 1.771,0.365 10 false Luggage Compartment Door Lock Assembly 1.135,1.75 3.438,2.115 2.302,0.365 10 false Luggage Compartment Door Courtesy Light Switch 1.177,1.51 2.167,2.031 0.99,0.521 10 false E 3.177,1.51 4.167,2.031 0.99,0.521 10 false D+ 6.052,1.135 6.667,1.333 0.615,0.198 10 false +B

CAUTION / NOTICE / HINT

NOTICE:

Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.


PROCEDURE

1.READ VALUE USING GTS
a.

Read the Data List according to the display on the GTS.

Body Electrical > Main Body > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Luggage Courtesy SW Luggage compartment door courtesy switch signal OFF or ON OFF: Luggage compartment door closed
ON: Luggage compartment door open
-
Body Electrical > Main Body > Data List
Tester Display
Luggage Courtesy SW
50003 123 53
OK:

Normal conditions listed above are displayed.



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

2.INSPECT LUGGAGE COMPARTMENT DOOR LOCK ASSEMBLY
2.INSPECT LUGGAGE COMPARTMENT DOOR LOCK ASSEMBLY

OK

3.CHECK HARNESS AND CONNECTOR (LUGGAGE COMPARTMENT DOOR LOCK ASSEMBLY - DRIVER SIDE JUNCTION BLOCK ASSEMBLY)

NG

REPLACE LUGGAGE COMPARTMENT DOOR LOCK ASSEMBLY

3.CHECK HARNESS AND CONNECTOR (LUGGAGE COMPARTMENT DOOR LOCK ASSEMBLY - DRIVER SIDE JUNCTION BLOCK ASSEMBLY)
a.

Disconnect the K1 luggage compartment door lock assembly connector.


b.

Disconnect the 4H driver side junction block assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(K1)Location & Routing

Click Connector(K1)Body>No. 1 Back Door Wire>Luggage Compartment Door Lock Assembly

K1-3 (D+) - 4H-27 Always Below 1 Ω
K1-3 (D+) or 4H-27 - Body ground Always 10 kΩ or higher
K1-2 (E) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

4.CHECK DRIVER SIDE JUNCTION BLOCK ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.CHECK DRIVER SIDE JUNCTION BLOCK ASSEMBLY
a.

Remove the driver side junction block assembly.

Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL

E361167C60
1.448,0.198 1.99,0.406 0.542,0.208 4.969,0.417 5.51,0.625 0.542,0.208 3.49,0.708 3.667,0.708 3.667,0.708 3.927,1.031 true 0.115,0.063 0.427,0.219 0.313,0.156 10 false *a 1.635,0.219 1.979,0.448 0.344,0.229 10 false 4H 5.188,0.438 5.531,0.667 0.344,0.229 10 false A 3.083,0.615 3.573,0.896 0.49,0.281 10 false LGCY
*a Component without harness connected
(Driver Side Junction Block Assembly)
- -



b.

Remove the main body ECU (multiplex network body ECU) from the driver side junction block assembly.

Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
4H-27 - A-4 (LGCY) Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

NG

REPLACE DRIVER SIDE JUNCTION BLOCK ASSEMBLY