The headlight ECU sub-assembly LH or headlight ECU sub-assembly RH stores a DTC if it detects an internal malfunction.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority | Note |
|---|---|---|---|---|---|---|
| B242C | Right Headlight ECU Malfunction | Detection condition:
Ignition switch ON Malfunction status:
Headlight ECU sub-assembly RH internal malfunction Malfunction duration:
Maximum 15 minutes |
Headlight ECU sub-assembly RH | AFS (Sub) | A | w/ Adaptive High Beam System |
| B242D | Left Headlight ECU Malfunction | Detection condition:
Ignition switch ON Malfunction status:
Headlight ECU sub-assembly LH internal malfunction Malfunction duration:
Maximum 15 minutes |
Headlight ECU sub-assembly LH | AFS | A | w/ Adaptive High Beam System |
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority | Note |
|---|---|---|---|---|---|---|
| B242C | Right Headlight ECU Malfunction | Detection condition:
Ignition switch ON Malfunction status:
Headlight ECU sub-assembly RH internal malfunction Malfunction duration:
Maximum 15 minutes |
Headlight ECU sub-assembly RH | HL AutoLeveling (Sub) | A | w/o Adaptive High Beam System |
| B242D | Left Headlight ECU Malfunction | Detection condition:
Ignition switch ON Malfunction status:
Headlight ECU sub-assembly LH internal malfunction Malfunction duration:
Maximum 15 minutes |
Headlight ECU sub-assembly LH | HL AutoLeveling | A | w/o Adaptive High Beam System |
If the headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the headlight ECU sub-assembly LH.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>REGISTRATION
Check vehicle condition.
| Result | Proceed to |
|---|---|
| w/ Adaptive High Beam System | A |
| w/o Adaptive High Beam System | B |
A
B
Pre-procedure1
None
Procedure1
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
Post-procedure1
None
NEXT
Pre-procedure1
Turn the ignition switch ON and wait for at least 10 seconds or more.
Procedure1
Check for DTCs.
| Result | Proceed to |
|---|---|
| B242C and B242D are not output | A |
| B242C is output | B |
| B242D is output | C |
Post-procedure1
None
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
C
Pre-procedure1
None
Procedure1
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
Post-procedure1
None
NEXT
Pre-procedure1
Turn the ignition switch ON and wait for at least 10 seconds or more.
Procedure1
Check for DTCs.
| Result | Proceed to |
|---|---|
| B242C and B242D are not output | A |
| B242C is output | B |
| B242D is output | C |
Post-procedure1
None
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
C