The vehicle height must be initialized for the headlight ECU sub-assembly LH to perform auto leveling control.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority | Note |
|---|---|---|---|---|---|---|
| B2450 | Height Sensor Initialization Incomplete | Detection condition:
Ignition switch ON Malfunction status:
ECU initialization incomplete Malfunction duration:
- |
Headlight ECU sub-assembly LH | AFS | A | w/ Adaptive Variable Suspension System |
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority | Note |
|---|---|---|---|---|---|---|
| B2450 | Height Sensor Initialization Incomplete | Detection condition:
Ignition switch ON Malfunction status:
ECU initialization incomplete Malfunction duration:
- |
Headlight ECU sub-assembly LH | HL AutoLeveling | A | w/o Adaptive Variable Suspension System |
If the headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the headlight ECU sub-assembly LH.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>REGISTRATION
Perform initialization of the headlight ECU sub-assembly LH.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>REGISTRATION
| Proceed to |
|---|
| NEXT |
NEXT
Check vehicle condition.
| Result | Proceed to |
|---|---|
| w/ Adaptive High Beam System | A |
| w/o Adaptive High Beam System | B |
A
B
Check for DTCs.
If the headlight ECU sub-assembly LH stores DTC B2450 even though the ECU has been initialized, there may be a malfunction in the headlight ECU sub-assembly LH.
| Result | Proceed to |
|---|---|
| B2450 is not output | A |
| B2450 is output | B |
A
B
Check for DTCs.
If the headlight ECU sub-assembly LH stores DTC B2450 even though the ECU has been initialized, there may be a malfunction in the headlight ECU sub-assembly LH.
| Result | Proceed to |
|---|---|
| B2450 is not output | A |
| B2450 is output | B |
A
B