When the adaptive high beam system is on, the main body ECU (multiplex network body ECU) illuminates the auto high beam switch indicator.
Inspect the fuses for circuits related to this system before performing the following procedure.
Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Automatic High Beam Switch Light | Auto high beam switch indicator light | OFF or ON | - |
| Tester Display |
|---|
| Automatic High Beam Switch Light |
Auto high beam switch indicator light illuminates.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Click hereADAS / AD>ADVANCED DRIVER ASSISTANCE SYSTEM>AUTOMATIC HIGH BEAM MAIN SWITCH>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the D109 auto high beam switch connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(D109)Location & Routingewd_type=routing;type=c;code=D109 Click Connector(D109)Instrument Panel>Instrument Panel Wire>Auto High Beam Switchewd_type=component;type=c;code=D109;pinno=3 |
||
| D109-3 (IND+) - Body ground | Ignition switch off | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the D109 auto high beam switch connector.
Disconnect the D14 main body ECU (multiplex network body ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(D109,D14)Location & Routingewd_type=routing;type=c,c;code=D109,D14 Click Connector(D109)Instrument Panel>Instrument Panel Wire>Auto High Beam Switchewd_type=component;type=c;code=D109;pinno=4 Click Connector(D14)Instrument Panel>Instrument Panel Wire>Main Body ECUewd_type=component;type=c;code=D14;pinno=21 |
||
| D109-4 (AZBI) - D14-21 (AHID) | Always | Below 1 Ω |
| D109-4 (AZBI) or D14-21 (AHID) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG