| *1 | HOSE CLAMP | - | - |
If the water remaining inside the FC exhaust pipe is hot, do not touch the water directly.
Touching the water remaining inside the FC exhaust pipe when it is hot could result in burns.
When the vehicle is parked with the power switch off, if the FC control ECU judges that the FC stack temperature will go below 0°C (32°F), it activates the FC air compressor, hydrogen pump and FC cooling water pump for a maximum of 180 seconds and drains water from the FC stack assembly. When performing inspection or repairs with the power switch off (not on (IG) or on (READY)), disconnect the cable from the negative (-) auxiliary battery terminal before performing work.
58404B
1.REMOVE REAR NO. 4 FLOOR BOARD SUB-ASSEMBLY
58403L
2.REMOVE REAR NO. 3 FLOOR BOARD SUB-ASSEMBLY
57628E
4.REMOVE REAR FLOOR SIDE MEMBER COVER LH
17DB3
5.REMOVE NO. 3 FC EXHAUST PIPE
|
|
To prevent contamination by foreign matter or water droplets, cover the connecting portions of the No. 3 FC exhaust pipe and No. 2 FC exhaust pipe with plastic bags.
17DB2
6.REMOVE NO. 2 FC EXHAUST PIPE
|
|
To prevent contamination by foreign matter or water droplets, cover the connecting portions of the No. 2 FC exhaust pipe and FC exhaust tailpipe assembly with plastic bags.
17DB0
7.REMOVE FC EXHAUST TAILPIPE ASSEMBLY
|
|
To prevent contamination by foreign matter or water droplets, cover the connecting portions of the FC exhaust tailpipe assembly and No. 1 FC exhaust pipe with plastic bags.
17DB1
8.REMOVE NO. 1 FC EXHAUST PIPE
|
|
To prevent contamination by foreign matter or water droplets, cover the connecting portions of the No. 1 FC exhaust pipe and FC stack air outlet hose with plastic bags.