Home › Vehicle Interior › DOOR LOCK › POWER DOOR LOCK CONTROL SYSTEM
RM37H0E _58 Vehicle Interior _095313 DOOR LOCK _0452394 POWER DOOR LOCK CONTROL SYSTEM J

DOOR LOCK  POWER DOOR LOCK CONTROL SYSTEM  All Doors LOCK/UNLOCK Functions do not Operate Via Door Key Cylinder  


DESCRIPTION

The main body ECU (multiplex network body ECU) receives door key cylinder lock or unlock switch signals from the front door with motor lock assembly (for Driver Door). The main body ECU (multiplex network body ECU) activates the door lock motor on each door according to these signals.

WIRING DIAGRAM

B494156E24
0.677,2.646 2.865,3.021 2.188,0.375 10 false Main Body ECU (Multiplex Network Body ECU) 0.667,2.469 1.125,2.667 0.458,0.198 10 false D14 4.385,2.292 5.573,2.5 1.188,0.208 10 false E21*1, E3*2,*3 4.375,2.448 6.563,2.823 2.188,0.375 10 false Front Door with Motor Lock Assembly (for Driver Door) 1.938,1.125 2.396,1.323 0.458,0.198 10 false L2 1.865,1.813 2.323,2.01 0.458,0.198 10 false UL3 4.75,1.146 5.208,1.344 0.458,0.198 10 false L 3.771,1.802 4.75,2 0.979,0.198 10 false 10*1, 5*2, 7*3 3.833,1.125 4.823,1.427 0.99,0.302 10 false 9*1, 6*2, 8*3 4.729,1.802 5.188,2.042 0.458,0.24 10 false UL 5.698,1.49 6.156,1.729 0.458,0.24 10 false E 5.927,1.479 6.833,1.708 0.906,0.229 10 false 7*1, 8*2, 6*3 2.188,1.115 2.646,1.354 0.458,0.24 10 false 18 2.188,1.792 2.646,2.031 0.458,0.24 10 false 17 1.167,0.875 1.625,1.073 0.458,0.198 10 false +B 1.167,1.542 1.625,1.74 0.458,0.198 10 false +B 0.208,3.229 1.396,3.438 1.188,0.208 10 false *1: for LHD 0.219,3.448 3.198,3.781 2.979,0.333 10 false *2: for RHD (w/o Double Door Locking System) 3.281,3.219 6.688,3.521 3.406,0.302 10 false *3: for RHD (w/ Double Door Locking System)

CAUTION / NOTICE / HINT

NOTICE:

If the main body ECU (multiplex network body ECU) is replaced, refer to the Service Bulletin.


PROCEDURE

1.READ VALUE USING GTS (Door Key SW-Lock, D Door Key SW-UL)
a.

Read the Data List according to the display on the GTS.

Body Electrical > Main Body > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Door Key SW-Lock Driver door key-linked switch lock signal OFF or ON OFF: Driver door key cylinder not turned to lock position
ON: Driver door key cylinder turned to lock position
-
D Door Key SW-UL Driver door key-linked switch unlock signal OFF or ON OFF: Driver door key cylinder not turned to unlock position
ON: Driver door key cylinder turned to unlock position
-
Body Electrical > Main Body > Data List
Tester Display
Door Key SW-Lock
D Door Key SW-UL
50003 123 19,21
OK:

On the GTS screen, ON or OFF is displayed for each item according to the table above.



Result:
Proceed to
OK
NG



OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

NG

2.INSPECT FRONT DOOR WITH MOTOR LOCK ASSEMBLY (for Driver Door)
2.INSPECT FRONT DOOR WITH MOTOR LOCK ASSEMBLY (for Driver Door)

Click hereVehicle Interior>DOOR LOCK>FRONT DOOR LOCK>INSPECTION

Result:
Proceed to
OK
NG



OK

3.CHECK HARNESS AND CONNECTOR (FRONT DOOR WITH MOTOR LOCK ASSEMBLY (for Driver Door) - MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) AND BODY GROUND)

NG

REPLACE FRONT DOOR WITH MOTOR LOCK ASSEMBLY (for Driver Door)

3.CHECK HARNESS AND CONNECTOR (FRONT DOOR WITH MOTOR LOCK ASSEMBLY (for Driver Door) - MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) AND BODY GROUND)
a.

Disconnect the E21*1 or E3*2 front door with motor lock assembly (for Driver Door) connector.

*1: for LHD

*2: for RHD



b.

Disconnect the D14 main body ECU (multiplex network body ECU) connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
for LHD:
Tester Connection Condition Specified Condition

Click Location & Routing(E21,D14)Location & Routing

Click Connector(E21)Body>Front Door Wire LH / Front Door Wire RH>Front Door Lock with Motor Assembly LH

Click Connector(D14)Instrument Panel>Instrument Panel Wire>Main Body ECU

E21-9 (L) - D14-18 (L2) Always Below 1 Ω
E21-10 (UL) - D14-17 (UL3) Always Below 1 Ω
E21-7 (E) - Body ground Always Below 1 Ω
E21-9 (L) or D14-18 (L2) - Other terminals and body ground Always 10 kΩ or higher
E21-10 (UL) or D14-17 (UL3) - Other terminals and body ground Always 10 kΩ or higher


Standard Resistance:
for RHD(w/ Double Lock Operation):
Tester Connection Condition Specified Condition

Click Location & Routing(E3,D14)Location & Routing

Click Connector(E3)Body>Front Door Wire LH / Front Door Wire RH>Front Door Lock with Motor Assembly RH

Click Connector(D14)Instrument Panel>Instrument Panel Wire>Main Body ECU

E3-8 (L) - D14-18 (L2) Always Below 1 Ω
E3-7 (UL) - D14-17 (UL3) Always Below 1 Ω
E3-6 (E) - Body ground Always Below 1 Ω
E3-8 (L) or D14-18 (L2) - Other terminals and body ground Always 10 kΩ or higher
E3-7 (UL) or D14-17 (UL3) - Other terminals and body ground Always 10 kΩ or higher


Standard Resistance:
for RHD(w/o Double Lock Operation):
Tester Connection Condition Specified Condition

Click Location & Routing(E3,D14)Location & Routing

Click Connector(E3)Body>Front Door Wire LH / Front Door Wire RH>Front Door Lock with Motor Assembly RH

Click Connector(D14)Instrument Panel>Instrument Panel Wire>Main Body ECU

E3-6 (L) - D14-18 (L2) Always Below 1 Ω
E3-5 (UL) - D14-17 (UL3) Always Below 1 Ω
E3-8 (E) - Body ground Always Below 1 Ω
E3-6 (L) or D14-18 (L2) - Other terminals and body ground Always 10 kΩ or higher
E3-5 (UL) or D14-17 (UL3) - Other terminals and body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR