| *A | for Front Passenger Side | *B | for Driver Side |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front door lock assembly removal/installation are shown below.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
When removing the front door glass sub-assembly LH, move the front door glass sub-assembly LH to the lowest position before disconnecting the auxiliary battery negative (-) terminal.
1. PRECAUTION
2.DISCONNECT CABLE TO NEGATIVE CONNECTOR AUXILIARY BATTERY TERMINAL
|
|
4.REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)
5.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)
67492A
7.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH
68172A
8.REMOVE FRONT DOOR GLASS INNER WEATHERSTRIP
68195B
9.REMOVE FRONT DOOR BELT REAR SEAL
68193C
10.REMOVE FRONT DOOR BELT FRONT SEAL
86160
11.REMOVE FRONT NO. 1 SPEAKER ASSEMBLY
89223
12.REMOVE MULTIPLEX NETWORK FRONT DOOR ECU
68151C
15.REMOVE FRONT DOOR GLASS RUN
67404F
16.REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY
69312
20.DISCONNECT FRONT DOOR LOCK OPEN ROD
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Detach the snap to separate the front door lock open rod from the front door outside handle frame sub-assembly as shown in the illustration.
69040A
21.REMOVE FRONT DOOR LOCK WITH MOTOR ASSEMBLY
|
TORX Screw |
|
Connector |
Disconnect the connector.
Using a T30 "TORX" socket wrench, remove the 3 TORX screws and remove the front door lock assembly LH.
69312
22.REMOVE FRONT DOOR LOCK OPEN ROD
|
Remove in this Direction | - | - |
69036A
23.REMOVE FRONT DOOR LOCK COVER SUB-ASSEMBLY
|
Open | - | - |
Using a screwdriver with its tip wrapped in protective tape, disengage the claw to open the front door lock cover sub-assembly.
Disengage the claw to remove the front door lock cover sub-assembly.
69710D
24.REMOVE FRONT DOOR LOCK OPEN LEVER REMOTE CONTROL CABLE
|
Remove in this Direction | - | - |
69750E
25.REMOVE FRONT DOOR INSIDE LOCK/UNLOCK KNOB LOCKING CABLE
|
Remove in this Direction | - | - |
69318C
26.REMOVE DOOR LOCK WIRING HARNESS SEAL
|
|
When reusing the front door with motor lock assembly:
Remove the door lock wiring harness seal from the front door lock with motor assembly.