Home › Vehicle Interior › DOOR LOCK › DOOR CONTROL RECEIVER
RM37H0E _58 Vehicle Interior _095313 DOOR LOCK _0453007 DOOR CONTROL RECEIVER A

DOOR LOCK  DOOR CONTROL RECEIVER  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
B608668N02
6.833,0.208 6.5,0.208 false 6.781,0.583 6.531,0.583 false 6.271,1.01 6.104,1.01 false 2.458,1.323 2.125,1.323 false 6.229,2.448 5.896,2.448 false 4.646,3.167 4.646,2.865 false 1.563,3.313 1.229,3.313 false 1.698,4.438 1.365,4.438 false 4.813,4.938 4.813,4.635 false 6.292,0.063 6.573,0.417 0.281,0.354 18 false 1 6.333,0.438 6.615,0.792 0.281,0.354 18 false 2 6.542,0.896 6.823,1.25 0.281,0.354 18 false 9 2.51,1.198 2.792,1.552 0.281,0.354 18 false 7 2.573,1.823 2.854,2.177 0.281,0.354 10 false x2 6.313,2.292 6.594,2.646 0.281,0.354 18 false 8 4.583,3.177 4.865,3.531 0.281,0.354 18 false 3 1.01,3.146 1.292,3.5 0.281,0.354 18 false 4 1.188,4.281 1.469,4.635 0.281,0.354 18 false 5 4.75,4.969 5.031,5.323 0.281,0.354 18 false 6 1.021,0.792 1.302,1.146 0.281,0.354 10 false x4

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION - (Click here) - -
2 CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL - - - -
3 LUGGAGE TRIM SERVICE HOLE COVER 64718B - - -
4 LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY 64701 - - -
5 TOOL BOX 75201A - - -
6 REAR FLOOR FINISH PLATE 58387 - - -
7 FRONT LUGGAGE COMPARTMENT TRIM COVER 64075B - - -
8 LUGGAGE COMPARTMENT TRIM INNER COVER RH 64721 - - -
9 ELECTRICAL KEY AND TPMS RECIEVER ASSEMBLY 897B0A (Click here) - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the door control receiver removal/installation are shown below.

Replacement Part Necessary Procedure Effect/Inoperative Function When Necessary Procedures are not Performed Link

*: When performing learning using the GTS.

Removal and installation of auxiliary battery terminal Memorize steering angle neutral point Lane control system (for Stereo camera type) for Stereo Camera type:
for Mono Camera type:
Lane control system (for Mono camera type)
Parking support brake system*
Pre-collision system (for Stereo camera type)
Pre-collision system (for Mono camera type)
Adaptive high beam system
Lighting system (EXT)

Cornering lights


Variable gear ratio steering system
Parking assist monitor system
Panoramic view monitor system
Initialize Rear Door Sunshade System Rear door sunshade system
Initialize power trunk lid system Power trunk lid system
·

Tire pressure warning ECU and receiver

·

Tire pressure warning valve and transmitter


·

Register transmitter ID

·

Initialize tire pressure warning system

·

Perform tire position identification


·

When DTC detection conditions of "transmitter ID not received" DTC are met, TPWS indicator blinks for 1 minute, and then illuminates.

·

Tire pressure warning function


for Initialization:
for Registration:

PROCEDURE

Hide 1. PRECAUTION

Z101186

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

Click here(Click here)



Hide 2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 64718B 3.REMOVE LUGGAGE TRIM SERVICE HOLE COVER

Hide 64701 4.REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

Hide 58387 6.REMOVE REAR FLOOR FINISH PLATE

Hide 64075B 7.REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER

Hide 64721 8.REMOVE LUGGAGE COMPARTMENT TRIM INNER COVER RH

Hide 897B0A 9.REMOVE ELECTRICAL KEY AND TPMS RECIEVER ASSEMBLY

a.
B608491C01
0,0 0,0 false
V100135

Bolt
V100136

Connector


i.

Remove the bolt.


ii.

Disengage the guide.


iii.

Disconnect the connector and remove the electrical key and TPMS receiver assembly.

NOTICE:

Do not subject the electrical key and TPMS receiver assembly to strong impacts or force, and do not drop it.