CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU), DRIVER SIDE JUNCTION BLOCK ASSEMBLY
| *1 | Main Body ECU (Multiplex Network Body ECU) | - | - |
Remove the main body ECU (multiplex network body ECU) from the driver side junction block assembly.
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL
Connect the instrument panel junction block assembly connectors.
| Terminal No. (Symbol) | Terminal Description | Condition | Specified Condition |
|---|---|---|---|
| A-32 (IG) - Body ground | Ignition power supply | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V | ||
| A-31 (BECU) - Body ground | Auxiliary battery power supply | Ignition switch off | 11 to 14 V |
| A-30 (ACC) - Body ground | ACC power supply | Ignition switch ACC | 11 to 14 V |
| Ignition switch off | Below 1 V | ||
| A-11 (GND1) - Body ground | Ground | Always | Below 1 Ω |
Install the main body ECU (multiplex network body ECU).
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>INSTALLATION
Measure the voltage according to the value(s) in the table below.
| Terminal No. (Symbol) | Terminal Description | Condition | Specified Condition |
|---|---|---|---|
| D14-16 (RET) - Body ground | Power retract mirror motor drive voltage | Retractable outer mirror switch on outer mirror switch assembly retracted position | Below 1 V |
| Retractable outer mirror switch on outer mirror switch assembly driving position | 11 to 14 V | ||
| D14-6 (AMR) - Body ground | Power retract mirror motor drive voltage | Retractable outer mirror switch on outer mirror switch assembly auto retracted position | Below 1 V |
| Retractable outer mirror switch on outer mirror switch assembly driving position | 11 to 14 V | ||
| D11-10 (RETR) - Body ground | Power retract mirror motor drive voltage | Outer rear view mirror assembly moves to the retracted position | Below 1 V |
| Outer rear view mirror assembly does not move | 11 to 14 V | ||
| D11-11 (RTRR) - Body ground | Power retract mirror motor drive voltage | Outer rear view mirror assembly moves to the driving position | Below 1 V |
| Outer rear view mirror assembly does not move | 11 to 14 V |