Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM
RM37H0E _59 Vehicle Exterior _095305 WINDOW / GLASS _0453652 POWER WINDOW CONTROL SYSTEM J

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM  Key-off Operation Function Operates even if Operating Conditions are not Satisfied  


DESCRIPTION

·

When the front doors are closed, each power window regulator motor assembly can control its power window operation for approximately 43 seconds after the ignition switch is turned from ON to off by receiving operation permission signals from the main body ECU (multiplex network body ECU).

·

However, when approximately 43 seconds have elapsed, or the driver door or front passenger door is opened within approximately 43 seconds of the ignition switch off being turned off, the power window regulator motor assembly stops operating.

·

During an auto operation, when 43 seconds have passed and key-off operation is prohibited, the power window stops immediately.


CAUTION / NOTICE / HINT

NOTICE:
·

The power window control system uses the LIN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the power window control system after confirming that the communication system is functioning properly.

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING

·

If a power window regulator motor assembly has been replaced with a new one, initialize the power window control system.

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION

·

If the main body ECU (multiplex network body ECU) is replaced, refer to Service Bulletin.



PROCEDURE

1.CHECK MANUAL UP / DOWN FUNCTION
a.

Check that the manual up and down function using the multiplex network master switch assembly and power window regulator switch assembly can operate the power windows.

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK

OK:

Manual up and down function is normal.



Result:
Proceed to
OK
NG



OK

2.CHECK REMOTE UP / DOWN FUNCTION

NG

2.CHECK REMOTE UP / DOWN FUNCTION
a.

Check that the remote up and down function using the multiplex network master switch assembly can operate all the power windows.

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK

OK:

Remote up and down function is normal.



Result:
Proceed to
OK
NG



OK

3.CHECK KEY-OFF OPERATION FUNCTION

NG

3.CHECK KEY-OFF OPERATION FUNCTION
a.

Check the key-off operation function.

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK


Result:
Result Proceed to
Power window can still be operated even after opening driver door or front passenger door within approximately 43 seconds of ignition switch being turned off A
Power window can still be operated even after approximately 43 seconds have elapsed after ignition switch is turned off (All Doors) B
Power window can still be operated even after approximately 43 seconds have elapsed after ignition switch is turned off (Driver door power window) (for LHD) C
Power window can still be operated even after approximately 43 seconds have elapsed after ignition switch is turned off (Driver door power window) (for RHD) D
Power window can still be operated even after approximately 43 seconds have elapsed after ignition switch is turned off (Front passenger door power window) (for LHD) E
Power window can still be operated even after approximately 43 seconds have elapsed after ignition switch is turned off (Front passenger door power window) (for RHD) F
Power window can still be operated even after approximately 43 seconds have elapsed after ignition switch is turned off (Rear LH door) G
Power window can still be operated even after approximately 43 seconds have elapsed after ignition switch is turned off (Rear RH door) H



A

4.READ VALUE USING GTS (MAIN BODY)

B

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

C

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

D

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH

E

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH

F

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

G

REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

H

REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY RH

4.READ VALUE USING GTS (MAIN BODY)
a.

Read the Data List according to the display on the GTS.

Body Electrical > Main Body > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
FR Door Courtesy SW Courtesy light switch RH signal OFF or ON OFF: Front door RH closed
ON: Front door RH open
for RHD
FL Door Courtesy SW Courtesy light switch LH signal OFF or ON OFF: Front door LH closed
ON: Front door LH open
for LHD
Body Electrical > Main Body > Data List
Tester Display
FR Door Courtesy SW
FL Door Courtesy SW
50003 123 197,199
OK:

On the GTS screen, ON or OFF is displayed accordingly.



Result:
Proceed to
OK
NG



OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

NG