Use the following procedure to troubleshoot the ASC system.
*: Use the GTS.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
Measure the auxiliary battery voltage with the ignition switch off.
11 to 14 V
If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding to the next step.
| Proceed to |
|---|
| NEXT |
NEXT
Use the GTS to check if the CAN communication system is functioning normally.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
| Result | Proceed to |
|---|---|
| CAN communication system DTCs are not output. | A |
| CAN communication system DTCs are output. | B |
A
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Check for DTCs and note any codes that are output.
Clear the DTCs.
Recheck for DTCs. Try to reproduce the ASC system DTCs by duplicating the conditions indicated by the DTCs.
DTCs are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Refer to Problem Symptoms Table.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>ASC SYSTEM>PROBLEM SYMPTOMS TABLE
| Result | Proceed to |
|---|---|
| Fault is not listed in Problem Symptoms Table. | A |
| Fault is listed in Problem Symptoms Table. | B |
A
B
Operation Check
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>ASC SYSTEM>OPERATION CHECK
Terminals of ECU
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>ASC SYSTEM>TERMINALS OF ECU
Data List / Active Test
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>ASC SYSTEM>DATA LIST / ACTIVE TEST
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT