CHECK AUTO OPERATION
Make sure that initialization has been completed before inspection.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF SUNSHADE SYSTEM>INITIALIZATION
The roof sunshade auto operation can be customized. Make sure that the auto operation is ON.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF SUNSHADE SYSTEM>CUSTOMIZE PARAMETERS
When pressing the switch for 0.3 seconds or less, the roof sunshade moves but auto operation does not operate.
Turn the ignition switch to ON.
When the roof sunshade is fully closed, press the open switch for 0.3 seconds or more. Check that the roof sunshade automatically opens until it is fully opened.
When the roof sunshade is fully open, press the close switch for 0.3 seconds or more. Check that the roof sunshade automatically closes until it is fully closed.
When the auto operation is operating, check that pressing any map light assembly stops the roof sunshade operation.
CHECK JAM PROTECTION FUNCTION
Do not use a part of your body, for example, your hand, to check the jam protection function.
Do not allow anything to become caught in the roof sunshade by accident while performing this inspection.
If the jam protection function does not operate, perform the initialization procedure for the roof sunshade ECU (sliding roof drive gear sub-assembly).
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF SUNSHADE SYSTEM>INITIALIZATION
If a hard object such as the handle of a hammer is used to activate jam protection, the roof sunshade may be deformed or damaged.
The jam protection function operates during both auto and manual operation.
Move the roof sunshade to the fully open position.
Hold a hammer handle sufficiently wrapped with a cloth or other material near the fully closed position.
When the roof sunshade is fully closed by an auto-close operation, check that the hammer handle is not caught, and the roof sunshade moves to the fully open position or stops at a position approximately 218 mm (8.58 in.) from where the jam protection function operated.