Home › Power Source / Network › BATTERY / CHARGING › BATTERY CURRENT SENSOR
RM37H0E _57 Power Source / Network _097006 BATTERY / CHARGING _0454572 BATTERY CURRENT SENSOR A

BATTERY / CHARGING  BATTERY CURRENT SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
A478439N01
5.99,1.75 6.365,1.75 false 5.854,2.396 6.229,2.396 false 5.302,2.896 5.677,2.896 false 4.542,2.323 4.917,2.323 false 6.417,0.24 6.792,0.24 false 5.021,0.677 5.396,0.677 false 6.271,0.115 6.552,0.469 0.281,0.354 18 false 1 4.844,0.521 5.125,0.875 0.281,0.354 18 false 2 6.292,2.26 6.573,2.615 0.281,0.354 18 false 3 5.125,2.823 5.438,3.021 0.313,0.198 10 false *1 4.354,2.25 4.667,2.448 0.313,0.198 10 false *2 6.417,1.688 6.729,1.885 0.313,0.198 10 false *3

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION - (Click here) - -
2 LUGGAGE TRIM SERVICE HOLE COVER 64718B - - -
3 BATTERY STATE SENSOR ASSEMBLY 28850C

*1 BATTERY CURRENT SENSOR HOLDER *2 GROUND WIRE
*3 NO. 1 LUGGAGE ROOM WIRE - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during battery state sensor assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (Click here)

HINT:

When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

Learning completes when vehicle is driven
Effect/Inoperative Function when Necessary Procedure not Performed Necessary Procedure Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Adaptive high beam system

Learning completes when vehicle is operated normally
Effect/Inoperative Function when Necessary Procedure not Performed Necessary Procedure Link
Air Conditioning System After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. -


PROCEDURE

Hide 1. PRECAUTION

Z101186

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

Click here(Click here)



Hide 64718B 2.REMOVE LUGGAGE TRIM SERVICE HOLE COVER

Hide 28850C 3.REMOVE BATTERY STATE SENSOR ASSEMBLY

a.
A478440