| *A | for LHD | *B | for RHD |
| *C | for 3 Zone Type | *D | for Dual Type |
| *1 | HEATER CASE (for Front Side) | *2 | HEATER CASE (for Rear Side) |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during No. 1 cooler thermistor removal/installation are shown below.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
| Effect/Inoperative Function When Necessary Procedures are not Performed | Necessary Procedures | Link |
|---|---|---|
| Air conditioning system | After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. | - |
When removing the air conditioning radiator damper servo sub-assembly, reinstallation is easier to perform if the following conditions are set before disconnecting the negative (-) battery terminal.
| Item | Condition |
|---|---|
| Air vent damper position | Face |
| Set temperature | Max cool |
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
87130D
1.REMOVE BLOWER ASSEMBLY
87128
2.REMOVE HEATER GROMMET
88H99
3.REMOVE COOLING UNIT PARTS
88536B
4.REMOVE NO. 3 COOLING UNIT BRACKET
87124C
5.REMOVE HEATER CLAMP
87107B
6.REMOVE HEATER RADIATOR UNIT SUB-ASSEMBLY
82210K
7.DISCONNECT AIR CONDITIONING HARNESS ASSEMBLY
| *A | for 3 Zone Type | *B | for Dual Type |
88H92
8.REMOVE NO. 2 COOLER COVER
88710H
9.REMOVE AIR CONDITIONING TUBE AND ACCESSORY ASSEMBLY
87050D
12.REMOVE NO. 2 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY
87050C
13.REMOVE NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY
88501
14.REMOVE NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY
88625
15.REMOVE NO. 1 COOLER THERMISTOR