Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › PEDESTRIAN PROTECTION SYSTEM
RM37H0E _58 Vehicle Interior _095287 SUPPLEMENTAL RESTRAINT SYSTEMS _0454682 PEDESTRIAN PROTECTION SYSTEM J

SUPPLEMENTAL RESTRAINT SYSTEMS  PEDESTRIAN PROTECTION SYSTEM  Warning Message on Multi-information Display  


DESCRIPTION

When there is a malfunction in the pop up hood (including disconnection of a connector) or the pedestrian protection sensors detect a pressure higher than the specified value, the airbag ECU assembly sends a signal to the combination meter assembly via CAN communication, and displays a message on the mulyi-display.

WIRING DIAGRAM

E346680E34
0.948,1.604 3.24,1.802 2.292,0.198 10 false Combination Meter Assembly 0.688,2.25 2.979,2.448 2.292,0.198 10 false : CAN communication Line 4.823,1.573 6.406,2.302 1.583,0.729 10 false Airbag ECU Assembly

PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
a.

Check if a CAN communication DTC is output.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM

OK:

DTC is not output.



Result:
Proceed to
OK
NG



OK

NG