Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › ULTRASONIC SENSOR (for Front)
RM37H0E _56 Audio / Visual / Telematics _095293 PARK ASSIST / MONITORING _0454704 ULTRASONIC SENSOR(for Front) A

PARK ASSIST / MONITORING  ULTRASONIC SENSOR(for Front)  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
B601962N01
2,0.115 4.417,1.083 2.417,0.969 5.417,1.75 7.083,3.333 1.667,1.583 2.844,4.083 3.427,4.083 false 5.74,2.188 5.99,2.188 false 2.417,0.625 2.583,0.625 false 3.479,0.854 3.729,0.854 false 3.042,1.323 3.375,1.323 false 2.313,1.74 2.229,1.74 2.229,1.74 2.229,1.406 false 3.177,1.896 3.51,1.896 false 4.677,2.302 5.01,2.302 false 4.719,3.573 4.635,3.573 4.635,3.573 4.635,3.24 false 6.292,3.063 6.208,3.063 6.208,3.063 6.208,2.729 false 4.156,2.729 3.99,2.729 3.99,2.729 3.99,2.396 false 3.563,3.938 3.844,4.292 0.281,0.354 18 false 1 3.583,1.76 3.865,2.115 0.281,0.354 18 false 2 4.219,2.594 4.5,2.948 0.281,0.354 18 false 2 3.438,1.188 3.719,1.542 0.281,0.354 18 false 3 5.083,2.177 5.365,2.531 0.281,0.354 18 false 3 6.063,2.073 6.344,2.427 0.281,0.354 18 false 4 3.813,0.729 4.094,1.083 0.281,0.354 18 false 4 2.958,0.521 3.229,0.813 0.271,0.292 10 false ● 2.688,1.646 2.958,1.938 0.271,0.292 10 false ● 5.104,3.469 5.375,3.76 0.271,0.292 10 false ● 6.656,2.969 6.927,3.26 0.271,0.292 10 false ● 2.813,1.615 3.094,1.969 0.281,0.354 18 false 5 5.24,3.417 5.521,3.771 0.281,0.354 18 false 5 3.083,0.479 3.365,0.833 0.281,0.354 18 false 6 6.802,2.927 7.083,3.281 0.281,0.354 18 false 6 2.073,0.167 2.448,0.406 0.375,0.24 12 false *A 5.5,1.802 5.875,2.042 0.375,0.24 12 false *A

Procedure Part Name Code
Z101186

Z101188

Z101187

1 FRONT BUMPER ASSEMBLY - - - -
2 FRONT CENTER ULTRASONIC SENSOR 89341L - - -
3 FRONT CORNER ULTRASONIC SENSOR 89341K - - -
4 FRONT SIDE ULTRASONIC SENSOR 89341M - - -
5 FRONT CORNER ULTRASONIC SENSOR RETAINER 89C48D (Click here) - -
6 FRONT SIDE ULTRASONIC SENSOR RETAINER 89C48F (Click here) - -

*A w/ Advanced Park - -
● Non-reusable part - -

B611770N05
3.313,1.948 3.521,2.188 3.521,2.188 3.76,2.188 false 4.031,2.042 4.583,2.396 0.552,0.354 18 false 7

Procedure Part Name Code
Z101186

Z101188

Z101187

7 ULTRASONIC SENSOR CUSHION SET 89305 (Click here) - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the ultrasonic sensor (for Front) removal/installation are shown below.

Necessary Procedures after parts removed/installed/replaced
Replaced Part or Performed Procedures Necessary Procedures Effect/Inoperative Function when Necessary Procedures are not Performed Link
Disconnect cable from negative (-) auxiliary battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (Click here)
Ultrasonic sensor (Including removal and installation)
·

Measurement of ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


·

TOYOTA Parking assist- sensor system

·

Parking support brake system

·

Advanced park


w/ Advanced Park:
(Click here)
w/o Advanced Park:
(Click here)
Front bumper assembly (Including removal and installation) Front television camera view adjustment Panoramic view monitor system (Click here)
·

Front television camera assembly, front bumper assembly or radiator grille

·

Rear television camera assembly

·

Side television camera assembly LH or outer rear view mirror assembly LH

·

Side television camera assembly RH or outer rear view mirror assembly RH


·

Television camera view adjustment

HINT:

Replacement or removal and installation of 2 or more parts


·

Rear television camera view adjustment (for Rear camera detection system)


Panoramic view monitor system

HINT:
·

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Adaptive high beam system


-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Air conditioning system After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. -




PROCEDURE

Hide 1.REMOVE FRONT BUMPER ASSEMBLY

Hide 89341L 2.REMOVE FRONT CENTER ULTRASONIC SENSOR

a.
B599549


b.

The orientation for the RH side is the opposite of the LH side.


Hide 89341K 3.REMOVE FRONT CORNER ULTRASONIC SENSOR

a.
B599548


b.

The orientation for the RH side is the opposite of the LH side.


Hide 89341M 4.REMOVE FRONT SIDE ULTRASONIC SENSOR (w/ Advanced Park)

a.
B599547


b.

The orientation for the RH side is the opposite of the LH side.


Hide 89C48D 5.REMOVE FRONT CORNER ULTRASONIC SENSOR RETAINER

Z101186

HINT:

Perform this procedure only when replacement of the front corner ultrasonic sensor retainer is necessary.



a.
B599648N03
1.948,0.302 2.229,0.656 0.281,0.354 18 false i 3.594,0.094 3.875,0.448 0.281,0.354 18 false ii

i.

Heat the adhesive of the front bumper assembly and front corner ultrasonic sensor retainer using a heat light.

Standard Value:
Part Temperature
Front Bumper Assembly 40 to 60 °C (104 to 140 °F)
Front Corner Ultrasonic Sensor Retainer 40 to 60 °C (104 to 140 °F)


CAUTION:
E306500C35
2.365,2 2.698,2 false 0.5,2.333 0.5,2.667 true 0.427,2.708 0.74,2.865 0.313,0.156 10 false *a 2.76,1.927 3.073,2.083 0.313,0.156 10 false *b
*a Heated Part
*b Heat Light


·

Do not touch the heat light and heated parts.

·

Touching the heat light may result in burns.

·

Touching heated parts for a long time may result in burns.



NOTICE:

Do not heat the front bumper assembly and front corner ultrasonic sensor retainer excessively.



ii.

Remove the front corner ultrasonic sensor retainer.



b.

The orientation for the RH side is the opposite of the LH side.


Hide 89C48F 6.REMOVE FRONT SIDE ULTRASONIC SENSOR RETAINER (w/ Advanced Park)

Z101186

HINT:

Perform this procedure only when replacement of the front side ultrasonic sensor retainer is necessary.



a.
B599649N02
1.948,0.302 2.229,0.656 0.281,0.354 18 false i 3.594,0.094 3.875,0.448 0.281,0.354 18 false ii

i.

Heat the adhesive of the front bumper assembly and front side ultrasonic sensor retainer using a heat light.

Standard Value:
Part Temperature
Front Bumper Assembly 40 to 60 °C (104 to 140 °F)
Front Side Ultrasonic Sensor Retainer 40 to 60 °C (104 to 140 °F)


CAUTION:
E306500C35
2.365,2 2.698,2 false 0.5,2.333 0.5,2.667 true 0.427,2.708 0.74,2.865 0.313,0.156 10 false *a 2.76,1.927 3.073,2.083 0.313,0.156 10 false *b
*a Heated Part
*b Heat Light


·

Do not touch the heat light and heated parts.

·

Touching the heat light may result in burns.

·

Touching heated parts for a long time may result in burns.



NOTICE:

Do not heat the front bumper assembly and front side ultrasonic sensor retainer excessively.



ii.

Remove the front side ultrasonic sensor retainer.



b.

The orientation for the RH side is the opposite of the LH side.


Hide 89305 7.REMOVE ULTRASONIC SENSOR CUSHION SET

Z101186

HINT:

Only perform this procedure when removing and installing the ultrasonic sensor cushion set.



a.
B611715C01
0,0 0,0 false
V113147

Remove in this Direction - -