| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | NO. 2 PARKING ASSIST ECU BRACKET | 86791D | - | - | - |
| 2 | NO. 1 PARKING ASSIST ECU BRACKET | 86791C | - | - | - |
| *1 | PARKING ASSIST ECU | - | - |
|
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
| *1 | NO. 1 ROOM PARTITION PAD | - | - |
|
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
| *A | w/ Seat Heater System | *B | w/ Climate Control Seat System |
| *1 | REAR SEAT OUTER BELT ASSEMBLY LH (FLOOR ANCHOR) | *2 | REAR SEAT OUTER BELT ASSEMBLY RH (FLOOR ANCHOR) |
| *3 | REAR SEAT INNER WITH CENTER BELT ASSEMBLY RH (FLOOR ANCHOR) | - | - |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) | ● | Non-reusable part |
A bolt without a torque specification is shown in the standard bolt chart.
Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS
86791D
1.INSTALL NO. 2 PARKING ASSIST ECU BRACKET
86791C
2.INSTALL NO. 1 PARKING ASSIST ECU BRACKET
3.INSTALL PARKING ASSIST ECU WITH BRACKET
| *A | w/o Advanced Park | *B | w/ Advanced Park |
|
Return in this Direction | - | - |
Install the parking assist ECU with bracket with the 2 nuts.
Connect the 6 connectors.
Return the No. 1 room partition pad as shown in the illustration.
62552F
4.INSTALL REAR SEAT SIDE GARNISH LH
67918F
6.INSTALL REAR DOOR SCUFF PLATE INSIDE LH
71398A
7.INSTALL REAR SEATBACK HOLDER
72693
9.INSTALL REAR SEAT CUSHION LOCK HOOK
14.PERFORM CALIBRATION