| *A | for Driver Side | *B | for Front Passenger Side |
| *1 | SEAT ADJUSTER SHIELD CLAMP BRACKET LH | - | - |
Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
84922C
1.INSTALL FRONT POWER SEAT SWITCH LH (for Driver Side)
| *1 | Seat Adjuster Shield Clamp Bracket LH | - | - |
Align the guide and set the front power seat switch RH and the seat adjuster shield clamp bracket LH to the front seat cushion shield LH.
Temporarily install the 4 screws.
Tighten the 4 screws in the order shown in the illustration and install the front power seat switch RH and the seat adjuster shield clamp bracket LH.
When tightening the front power seat switch RH with the screws, do not apply any force other than in the tightening direction.
84922B
2.INSTALL FRONT POWER SEAT SWITCH RH (for Front Passenger Side)
|
|
84921Q
3.INSTALL RECLINING POWER SEAT SWITCH KNOB
84921R
4.INSTALL SLIDE AND VERTICAL POWER SEAT SWITCH KNOB
71812D
5.INSTALL FRONT SEAT CUSHION SHIELD LH (for Driver Side)
71811D
6.INSTALL FRONT SEAT CUSHION SHIELD RH (for Front Passenger Side)
71868N
7.INSTALL FRONT SEAT FRONT CUSHION SHIELD LH
8.INSTALL FRONT SEAT ASSEMBLY LH