| *A | w/ Memory | *B | w/ Seat Heater System |
| *C | w/ Climate Control Seat System | - | - |
| *1 | FRONT SEAT OUTER BELT ASSEMBLY LH | - | - |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) | - | - |
Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The following procedure is for the LH side.
1.INSTALL FRONT SEAT ASSEMBLY LH
Place the front seat assembly LH in the cabin.
2 or more people are required when carrying the front seat assembly LH out of the vehicle.
Be careful not to damage the vehicle body.
| *A | for Driver Side | *B | for Front Passenger Side |
Connect the 2 connectors and clamp.
Connect the front seat airbag assembly connector.
Refer to How to Connect or Disconnect Airbag Connector.
Connect the cable to the negative (-) auxiliary battery terminal.
Click hereGeneral>MAINTENANCE>AUXILIARY BATTERY>INSTALLATION
Insert the 2 location pins of the front seat assembly through the 2 body holes and place the front seat assembly.
Temporarily install the front seat assembly with the 4 TORX screws.
Operate the slide and vertical power seat switch knob and move the front seat assembly to the frontmost position.
Using a T50 "TORX" socket wrench, tighten the 2 TORX screws in the order shown in the illustration.
Operate the slide and vertical power seat switch knob and move the front seat assembly to the rearmost position.
Using a T50 "TORX" socket wrench, tighten the TORX screws in the order shown in the illustration.
| *A | for Driver Seat | - | - |
for Driver Seat:
Operate the slide and vertical power seat switch knob and move the front seat assembly to the lowermost position.
Insert the guide.
Install the anchor of the front seat outer belt assembly LH with the bolt.
73179A
2.INSTALL SEAT BELT ANCHOR COVER CAP LH
72158E
3.INSTALL REAR INNER SEAT TRACK BRACKET COVER LH
72138N
4.INSTALL REAR OUTER SEAT TRACK BRACKET COVER LH
72128A
5.INSTALL FRONT INNER SEAT TRACK BRACKET COVER LH
72124
6.INSTALL FRONT OUTER SEAT TRACK BRACKET COVER LH
71910A
7.INSTALL FRONT SEAT HEADREST ASSEMBLY
8. INITIALIZATION OF SEAT ECU (w/ Memory)
11.INSPECT FRONT SEAT ASSEMBLY
14. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART