| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | FRONT SEATBACK HEATER ASSEMBLY LH | 87510N | ( )
|
- | - |
| 2 | FRONT SEATBACK COVER SUB-ASSEMBLY LH | 71074S | ( )
|
- | - |
| *1 | SEPARATE TYPE FRONT SEATBACK PAD LH | - | - |
| ● | Non-reusable part | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 3 | SEPARATE TYPE FRONT SEATBACK COVER WITH PAD LH | - | - | - | - |
| 4 | FRONT SEAT HEADREST SUPPORT | 71931 | - | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 5 | FRONT SEATBACK ASSEMBLY LH | - | - | - | - |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 6 | FRONT INNER SEAT CUSHION SHIELD LH | 71862 | - | - | - |
| 7 | FRONT INNER SEAT CUSHION SHIELD RH | 71861 | - | - | - |
| 8 | FRONT SEAT CUSHION SHIELD LH | 71812D | - | - | - |
| 9 | FRONT SEAT CUSHION SHIELD RH | 71811D | - | - | - |
| 10 | FRONT SEAT FRONT CUSHION SHIELD LH | 71868N | - | - | - |
| 11 | FRONT SEAT ASSEMBLY LH | - | - | - | - |
| *A | for Driver Side | *B | for Front Passenger Side |
Wear protective gloves. Sharp areas on the parts may injure your hands
There is risk of injury.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
87510N
1.INSTALL FRONT SEATBACK HEATER ASSEMBLY LH
| *a | Marking Line | - | - |
Remove the release paper of the front seatback heater assembly LH, align it with the marking line of the separate type front seatback pad in the order shown in the illustration, and install the front seatback heater assembly LH.
After remove the release paper, do not touch the tape surface with your fingers or gloves.
Do not reuse the front seatback heater assembly LH and the front seatback heater assembly LH because once removed, the surface becomes rough ahd the adhesive strength decreases.
Sufficiently crimp the tape part of the front seatback heater assembly LH and attach it.
3.INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD LH
71931
4.INSTALL FRONT SEAT HEADREST SUPPORT
5.INSTALL FRONT SEATBACK ASSEMBLY LH
71862
6.INSTALL FRONT INNER SEAT CUSHION SHIELD LH (for Driver Side)
71861
7.INSTALL FRONT INNER SEAT CUSHION SHIELD RH (for Front Passenger Side)
71812D
8.INSTALL FRONT SEAT CUSHION SHIELD LH (for Driver Side)
71811D
9.INSTALL FRONT SEAT CUSHION SHIELD RH (for Front Passenger Side)
71868N
10.INSTALL FRONT SEAT FRONT CUSHION SHIELD LH
11.INSTALL FRONT SEAT ASSEMBLY LH