Home › Vehicle Interior › SEAT › POWER SEAT CONTROL ECU
RM37H0E _58 Vehicle Interior _095292 SEAT _0454736 POWER SEAT CONTROL ECU A

SEAT  POWER SEAT CONTROL ECU  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
B607973N03
4.24,1.115 5.063,1.115 false 6.292,0.208 6.854,0.208 false 3.542,2.354 4.104,2.354 false 6.135,0.083 6.417,0.438 0.281,0.354 18 false 1 5.125,0.969 5.406,1.323 0.281,0.354 18 false 2 4.167,2.198 4.448,2.552 0.281,0.354 18 false 3 3.354,2.563 3.667,2.76 0.313,0.198 10 false x 3

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION - (Click here) - -
2 FRONT SEAT ASSEMBLY LH - - - -
3 POSITION CONTROL ECU ASSEMBLY LH 89710D - - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the power seat control ECU removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary procedures Effect/Inoperative Function when Necessary Procedure not Performed Link

*: Even when not replacing the part, it is necessary to perform the specified necessary procedures after installation.

Disconnect cable from negative (-) auxiliary battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (Click here)
Front power seat control system (w/ Memory)
·

Position control ECU assembly LH (for LHD)*

·

Position control ECU assembly RH (for RHD)*


Initialize position control ECU Front power seat control system (w/ Memory) (Click here)

CAUTION:
B543257

·

Wear protective gloves. Sharp areas on the parts may injure your hands.

·

There is risk of injury.



HINT:
·

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Adaptive high beam system


·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

Z101186

CAUTION:
B401522

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

(Click here)


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

(Click here)



Hide 2.REMOVE FRONT SEAT ASSEMBLY LH

Hide 89710D 3.REMOVE POSITION CONTROL ECU ASSEMBLY LH

a.
B607974C02
0,0 0,0 false
V100135

Connector
V100136

Screw