| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | REAR SEAT INNER WITH CENTER BELT ASSEMBLY RH | 73470B | ( )
|
- | - |
| 2 | PACKAGE TRAY TRIM PANEL ASSEMBLY | 64330 | ( )
|
- | - |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) |
|
N*m (kgf*cm, ft.*lbf) : Specified torque |
| ● | Non-reusable part | - | - |
| *A | w/ Seat Heater System | *B | w/ Climate Control Seat System |
| *1 | REAR SEAT OUTER BELT ASSEMBLY LH (FLOOR ANCHOR) | *2 | REAR SEAT OUTER BELT ASSEMBLY RH (FLOOR ANCHOR) |
| *3 | REAR SEAT INNER WITH CENTER BELT ASSEMBLY RH (FLOOR ANCHOR) | - | - |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) | ● | Non-reusable part |
Move both front seats to the frontmost position and fold them forward.
73470B
1.INSTALL REAR SEAT INNER WITH CENTER BELT ASSEMBLY RH
| *a | Unlock | *b | Lock |
| *c | 45° | - | - |
|
Bolt A |
|
Bolt B |
When the inclination of the retractor is 15° or less, check that the belt can be pulled from the retractor. When the inclination of the retractor is over 45°, check that the belt locks.
Do not disassemble the retractor.
Attach the guide.
Install the bolt B.
Install the bolt A.
64330
2.INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY
|
|
62440
3.INSTALL ROOF SIDE RAIL GARNISH ASSEMBLY LH
62430
4.INSTALL ROOF SIDE RAIL GARNISH ASSEMBLY RH
62480A
5.INSTALL INNER ROOF SIDE GARNISH ASSEMBLY LH
62470A
6.INSTALL INNER ROOF SIDE GARNISH ASSEMBLY RH
62488A
7.INSTALL INNER ROOF SIDE GARNISH COVER LH
62487A
8.INSTALL INNER ROOF SIDE GARNISH COVER RH
62552F
9.INSTALL REAR SEAT SIDE GARNISH LH
62551F
10.INSTALL REAR SEAT SIDE GARNISH RH
62331A
12.INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH
Use the same procedure described for the LH side.
67918F
13.INSTALL REAR DOOR SCUFF PLATE INSIDE LH
67917F
14.INSTALL REAR DOOR SCUFF PLATE INSIDE RH
73480A
15.INSTALL REAR SEAT INNER BELT ASSEMBLY LH
| *a | Protruding Part | - | - |
|
Bolt |
|
Connector |
Tighten the bolt and install the rear seat inner belt assembly LH.
Do not allow the anchor part of the rear seat inner belt assembly LH to overlap the protruding part.
Connect the 2 connectors.
71398A
16.INSTALL REAR SEATBACK HOLDER
72693
18.INSTALL REAR SEAT CUSHION LOCK HOOK