Home › Drivetrain › Q710 (HYBRID TRANSMISSION / TRANSAXLE) › ELECTRONIC SHIFT LEVER SYSTEM
RM37H0E _52 Drivetrain _093826 Q710 HYBRID TRANSMISSION / TRANSAXLE _0454877 ELECTRONIC SHIFT LEVER SYSTEM C

Q710 HYBRID TRANSMISSION / TRANSAXLE  ELECTRONIC SHIFT LEVER SYSTEM  U014000  Lost Communication with Body Control Module (Sub) Missing Message  U029300  Lost Communication with Hybrid/EV Powertrain Control Module from Gear Shift Control Module "A"  U110700  Lost Communication with Power Management Module (Gear Shift Control Module "A")  U117000  Lost Communication with Brake System Control Module (Gear Shift Control Module "A")  


DESCRIPTION

The shift control ECU transmits and receives signals via CAN communication to and from the main body ECU (multiplex network body ECU), EV control ECU, No. 2 skid control ECU (brake actuator assembly) and certification ECU (smart key ECU assembly).

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate DTC Output from Priority
U014000 Lost Communication with Body Control Module (Sub) Missing Message 2 seconds elapse after turning ignition switch to ON with auxiliary battery voltage 10 V or higher and a CAN communication malfunction between main body ECU (multiplex network body ECU) occurs continuously for 3.6 seconds or more.
(1 trip detection logic)
CAN communication system
·

Master Warning

-

Comes on


·

Multi-information Display Error Message

-

Displayed



EV B
U029300 Lost Communication with Hybrid/EV Powertrain Control Module from Gear Shift Control Module "A" 3 seconds elapse after turning ignition switch to ON with auxiliary battery voltage 10 V or higher and a CAN communication malfunction between EV control ECU occurs continuously for 10.6 seconds or more.
(1 trip detection logic)
CAN communication system
·

Master Warning

-

Comes on


·

Multi-information Display Error Message

-

Displayed



EV B
U110700 Lost Communication with Power Management Module (Gear Shift Control Module "A") 3 seconds elapse after turning ignition switch to ON with auxiliary battery voltage 10 V or higher and a CAN communication malfunction between certification ECU (smart key ECU assembly) occurs continuously for 3.6 seconds or more.
(1 trip detection logic)
CAN communication system
·

Master Warning

-

Comes on


·

Multi-information Display Error Message

-

Displayed



EV B
U117000 Lost Communication with Brake System Control Module (Gear Shift Control Module "A") 3 seconds elapse after turning ignition switch to ON with auxiliary battery voltage 10 V or higher and a CAN communication malfunction between No. 2 skid control ECU (brake actuator assembly) occurs continuously for 2.2 seconds or more.
(1 trip detection logic)
CAN communication system
·

Master Warning

-

Comes on


·

Multi-information Display Error Message

-

Displayed



EV B

CONFIRMATION DRIVING PATTERN

HINT:

After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the All Readiness check procedure.

Click hereDrivetrain>Q710 (HYBRID TRANSMISSION / TRANSAXLE)>ELECTRONIC SHIFT LEVER SYSTEM>UTILITY


1.

Turn the ignition switch to ON and wait for 2 minutes or more.


PROCEDURE

1.CHECK DTC OUTPUT (HEALTH CHECK)

Pre-procedure1

a.

Turn the ignition switch to ON.


Procedure1

a.

Using the GTS, perform a Health Check.

Result:
Result Proceed to
P176D12 is not output A
P176D12 is output B



Post-procedure1

a.

Turn the ignition switch off.



A

B