| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate | DTC Output from | Priority |
|---|---|---|---|---|---|---|
| C05D604 | Power Steering Control Module Processor System Internal Failure | When there is an internal malfunction in the ECU | Rack and pinion power steering gear assembly | EPS warning light: Comes on | EMPS | A |
| C05D646 | Power Steering Control Module Processor Calibration / Parameter Memory Failure | When there is an internal malfunction in the ECU | Rack and pinion power steering gear assembly | EPS warning light: Comes on | EMPS | A |
| C05D649 | Power Steering Control Module Processor Internal Electronic Failure | When there is an internal malfunction in the ECU | Rack and pinion power steering gear assembly | EPS warning light: Comes on | EMPS | A |
| C10001C | Control Module Internal Temperature Sensor "A" Circuit Voltage Out of Range | When there is an internal malfunction in the ECU | Rack and pinion power steering gear assembly | EPS warning light: Comes on | EMPS | A |
| C10051C | Control Module Internal Temperature Sensor "B" Circuit Voltage Out of Range | When there is an internal malfunction in the ECU | Rack and pinion power steering gear assembly | EPS warning light: Comes on | EMPS | A |
| C152A18 | Power Steering Motor "A" Circuit Current Below Threshold | Motor A speed is lower than the specified value, phase voltage command value is higher than the specified value, and phase current is lower than the specified value | Rack and pinion power steering gear assembly | EPS warning light: Comes on | EMPS | A |
| C152A19 | Power Steering Motor "A" Circuit Current Above Threshold | Each phase current of motor A is higher than the specified value | Rack and pinion power steering gear assembly | EPS warning light: Comes on | EMPS | A |
| C152B18 | Power Steering Motor "B" Circuit Current Below Threshold | Motor B speed is lower than the specified value, phase voltage command value is higher than the specified value, and phase current is lower than the specified value | Rack and pinion power steering gear assembly | EPS warning light: Comes on | EMPS | A |
| C152B19 | Power Steering Motor "B" Circuit Current Above Threshold | Each phase current of motor B is higher than the specified value | Rack and pinion power steering gear assembly | EPS warning light: Comes on | EMPS | A |
| C153A00 | Malfunction of Power Steering Motor "A" Inverter Pre-Driver | When there is an internal malfunction in the ECU | Rack and pinion power steering gear assembly | EPS warning light: Comes on | EMPS | A |
| C153A19 | Power Steering Motor "A" Inverter Circuit Current Above Threshold | When there is an internal malfunction in the ECU | Rack and pinion power steering gear assembly | EPS warning light: Comes on | EMPS | A |
| C153B00 | Malfunction of Power Steering Motor "B" Inverter Pre-Driver | When there is an internal malfunction in the ECU | Rack and pinion power steering gear assembly | EPS warning light: Comes on | EMPS | A |
| C153B19 | Power Steering Motor "B" Inverter Circuit Current Above Threshold | When there is an internal malfunction in the ECU | Rack and pinion power steering gear assembly | EPS warning light: Comes on | EMPS | A |
| C154A7E | Power Supply & Contrary Connection Protection Relay "A" Actuator Stuck On | When there is an internal malfunction in the ECU | Rack and pinion power steering gear assembly | EPS warning light: Comes on | EMPS | A |
| C154A7F | Power Supply & Contrary Connection Protection Relay "A" Actuator Stuck Off | When there is an internal malfunction in the ECU | Rack and pinion power steering gear assembly | EPS warning light: Comes on | EMPS | A |
| C154B7E | Power Supply & Contrary Connection Protection Relay "B" Actuator Stuck On | When there is an internal malfunction in the ECU | Rack and pinion power steering gear assembly | EPS warning light: Comes on | EMPS | A |
| C154B7F | Power Supply & Contrary Connection Protection Relay "B" Actuator Stuck Off | When there is an internal malfunction in the ECU | Rack and pinion power steering gear assembly | EPS warning light: Comes on | EMPS | A |
| C156A9E | Power Steering Motor "A" Shut Down Relay Stuck On | When there is an internal malfunction in the ECU | Rack and pinion power steering gear assembly | EPS warning light: Comes on | EMPS | A |
| C156A9F | Power Steering Motor "A" Shut Down Relay Stuck Off | When there is an internal malfunction in the ECU | Rack and pinion power steering gear assembly | EPS warning light: Comes on | EMPS | A |
| C156B9E | Power Steering Motor "B" Shut Down Relay Stuck On | When there is an internal malfunction in the ECU | Rack and pinion power steering gear assembly | EPS warning light: Comes on | EMPS | A |
| C156B9F | Power Steering Motor "B" Shut Down Relay Stuck Off | When there is an internal malfunction in the ECU | Rack and pinion power steering gear assembly | EPS warning light: Comes on | EMPS | A |
| C156C49 | Power Steering Motor "A" Shut Down Relay Monitoring Circuit Internal Electronic Failure | When there is an internal malfunction in the ECU | Rack and pinion power steering gear assembly | EPS warning light: Comes on | EMPS | A |
| C156D49 | Power Steering Motor "B" Shut Down Relay Monitoring Circuit Internal Electronic Failure | When there is an internal malfunction in the ECU | Rack and pinion power steering gear assembly | EPS warning light: Comes on | EMPS | A |
| C157A11 | Power Steering Motor "A" Current Sensor Circuit Short to Ground | Phase current is at or lower than the specified value | Rack and pinion power steering gear assembly | EPS warning light: Comes on | EMPS | A |
| C157A62 | Power Steering Motor "A" Current Sensor Signal Compare Failure | When the sum of each phase current of motor A exceeds the specified value | Rack and pinion power steering gear assembly | EPS warning light: Comes on | EMPS | A |
| C157B11 | Power Steering Motor "B" Current Sensor Circuit Short to Ground | Phase current is at or lower than the specified value | Rack and pinion power steering gear assembly | EPS warning light: Comes on | EMPS | A |
| C157B62 | Power Steering Motor "B" Current Sensor Signal Compare Failure | When the sum of each phase current of motor B exceeds the specified value | Rack and pinion power steering gear assembly | EPS warning light: Comes on | EMPS | A |
| C159A49 | Power Steering Motor "A" Terminal Voltage Detect Circuit Internal Electronic Failure | When there is an internal malfunction in the ECU | Rack and pinion power steering gear assembly | EPS warning light: Comes on | EMPS | A |
| C159B49 | Power Steering Motor "B" Terminal Voltage Detect Circuit Internal Electronic Failure | When there is an internal malfunction in the ECU | Rack and pinion power steering gear assembly | EPS warning light: Comes on | EMPS | A |
| C15D149 | Turn Counter Circuit "A" Internal Electronic Failure | When there is an internal malfunction in the ECU | Rack and pinion power steering gear assembly | EPS warning light: Comes on | EMPS | A |
| C15D162 | Power Steering Motor Position Sensor "A" Signal Compare Failure | Difference in rotation angle sensor signal is not as specified | Rack and pinion power steering gear assembly | EPS warning light: Comes on | EMPS | A |
| C15D187 | Power Steering Motor Position Sensor "A" Missing Message | Rotation angle sensor A lost communication | Rack and pinion power steering gear assembly | EPS warning light: Comes on | EMPS | A |
| C15D249 | Turn Counter Circuit "B" Internal Electronic Failure | When there is an internal malfunction in the ECU | Rack and pinion power steering gear assembly | EPS warning light: Comes on | EMPS | A |
| C15D262 | Power Steering Motor Position Sensor "B" Signal Compare Failure | Difference in rotation angle sensor signal is not as specified | Rack and pinion power steering gear assembly | EPS warning light: Comes on | EMPS | A |
| C15D287 | Power Steering Motor Position Sensor "B" Missing Message | Rotation angle sensor B lost communication | Rack and pinion power steering gear assembly | EPS warning light: Comes on | EMPS | A |
| C15D704 | Power Steering Control Module Processor (System 2) System Internal Failure | When there is an internal malfunction in the ECU | Rack and pinion power steering gear assembly | EPS warning light: Comes on | EMPS | A |
| C15D746 | Power Steering Control Module Processor (System 2) Calibration / Parameter Memory Failure | When there is an internal malfunction in the ECU | Rack and pinion power steering gear assembly | EPS warning light: Comes on | EMPS | A |
| C15D749 | Power Steering Control Module Processor (System 2) Internal Electronic Failure | When there is an internal malfunction in the ECU | Rack and pinion power steering gear assembly | EPS warning light: Comes on | EMPS | A |
| C15D862 | Turn Counter "A"/"B" Signal Compare Failure | Difference in rotation angle sensor signal is not as specified | Rack and pinion power steering gear assembly | EPS warning light: Comes on | EMPS | A |
When replacing the rack and pinion power steering gear assembly, perform Power Steering ECU Initial Setting.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>UTILITY
Pre-procedure1
None
Procedure1
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
Post-procedure1
Turn the ignition switch off.
NEXT
Check for DTCs.
| Result | Proceed to |
|---|---|
| C05D604, C05D646, C05D649, C10001C, C10051C, C152A18, C152A19, C152B18, C152B19, C153A00, C153A19, C153B00, C153B19, C154A7E, C154A7F, C154B7E, C154B7F, C156A9E, C156A9F, C156B9E, C156B9F, C156C49, C156D49, C157A11, C157A62, C157B11, C157B62, C159A49, C159B49, C15D149, C15D162, C15D187, C15D249, C15D262, C15D287, C15D704, C15D746, C15D749 or C15D862 is output | A |
| C05D604, C05D646, C05D649, C10001C, C10051C, C152A18, C152A19, C152B18, C152B19, C153A00, C153A19, C153B00, C153B19, C154A7E, C154A7F, C154B7E, C154B7F, C156A9E, C156A9F, C156B9E, C156B9F, C156C49, C156D49, C157A11, C157A62, C157B11, C157B62, C159A49, C159B49, C15D149, C15D162, C15D187, C15D249, C15D262, C15D287, C15D704, C15D746, C15D749 or C15D862 and other DTCs are output | B |
| DTCs are not output | C |
A
B
C
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING