Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM
RM37H0E _56 Audio / Visual / Telematics _095260 AUDIO / VIDEO _0455059 AUDIO AND VISUAL SYSTEM U

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  TERMINALS OF ECU  


HINT:

Check from the rear of the connector while it is connected to the components.


RADIO AND DISPLAY RECEIVER ASSEMBLY


E461107E01
1.073,0.354 1.5,0.646 0.427,0.292 2.75,0.354 3.177,0.646 0.427,0.292 3.375,1.833 3.802,2.125 0.427,0.292 5.802,0.354 6.229,0.646 0.427,0.292 4.313,0.354 4.74,0.646 0.427,0.292 1.417,1.885 1.844,2.177 0.427,0.292 1.167,0.396 1.49,0.594 0.323,0.198 10 false D66 1.5,1.917 1.823,2.115 0.323,0.198 10 false D54 2.802,0.396 3.188,0.594 0.385,0.198 10 false D147 4.375,0.396 4.698,0.594 0.323,0.198 10 false GPS 5.917,0.396 6.167,0.615 0.25,0.219 10 false RA 3.469,1.875 3.792,2.073 0.323,0.198 10 false D56

Terminal No. (Symbol) Terminal Description Condition Specified Condition
D66-1 (FR+) - D54-1 (GND1) Sound signal (Front right) Audio system playing A waveform synchronized with sound signals is output
D66-2 (FL+) - D54-1 (GND1) Sound signal (Front left) Audio system playing A waveform synchronized with sound signals is output
D66-3 (RL+) - D54-1 (GND1) Sound signal (Rear left) Audio system playing A waveform synchronized with sound signals is output
D66-4 (RR+) - D54-1 (GND1) Sound signal (Rear right) Audio system playing A waveform synchronized with sound signals is output
D66-6 (FR-) - D54-1 (GND1) Sound signal (Front right) Audio system playing A waveform synchronized with sound signals is output
D66-7 (FL-) - D54-1 (GND1) Sound signal (Front left) Audio system playing A waveform synchronized with sound signals is output
D66-8 (RL-) - D54-1 (GND1) Sound signal (Rear left) Audio system playing A waveform synchronized with sound signals is output
D66-9 (RR-) - D54-1 (GND1) Sound signal (Rear right) Audio system playing A waveform synchronized with sound signals is output
D54-1 (GND1) - Body ground Ground Always Below 1 Ω
D54-4 (+B1) - D54-1 (GND1) Power source (+B) Ignition switch off 11 to 14 V
D54-15 (ACC1) - D54-1 (GND1) Power source (ACC) Ignition switch off Below 1 V
Ignition switch ACC 11 to 14 V
D54-21 (SW1) - D54-24 (SWG) Steering pad switch signal No switch pushed 2.97 to 3.56 V
Seek+ switch pushed 0.27 to 0.35 V
Seek- switch pushed 0.86 to 1.03 V
Vol+ switch pushed 1.51 to 1.79 V
Vol- switch pushed 2.22 to 2.66 V
D54-22 (SW2) - D54-24 (SWG) Steering pad switch signal No switch pushed 2.97 to 3.56 V
MODE switch pushed 0.27 to 0.35 V
TEL switch pushed 1.51 to 1.79 V
Voice switch pushed 2.22 to 2.66 V
D54-24 (SWG) - D54-1 (GND1) Steering pad switch ground Always Below 1 Ω
D54-27 (SPD) - D54-1 (GND1) Vehicle speed signal See "Check Vehicle Signal" in Operation Check
Click here(Click here)
-
D54-28 (REV) - D54-1 (GND1) Reverse signal See "Check Vehicle Signal" in Operation Check
Click here(Click here)
-
D56-5 (CNH1) Local bus communication signal - -
D56-6 (CNL1) Local bus communication signal - -
D56-13 (CANH) CAN communication signal - -
D56-14 (CANL) CAN communication signal - -
D56-15 (ILL+) - D54-1 (GND1) Illumination signal Light control switch off Below 1 V
Light control switch in tail or head position 11 to 14 V
D56-16 (ILL-) - D54-1 (GND1) Illumination signal Light control switch off Below 1 V
Light control switch in tail or head position Pulse generation
D56-19 (IG) - D54-1 (GND1) Power source (IG) Ignition switch off Below 1 V
Ignition switch ON 11 to 14 V
D56-21 (MIN+) - D54-1 (GND1) Microphone voice signal See "Check Microphone" in Operation Check
Click here(Click here)
-
D56-22 (MIN-) - D54-1 (GND1) Microphone voice signal See "Check Microphone" in Operation Check
Click here(Click here)
-
D56-23 (MACC) - D54-1 (GND1) Microphone power supply Ignition switch off Below 1 V
Ignition switch ACC 4 to 6 V
D56-24 (SGND) - Body ground Shield ground Always Below 1 Ω
D56-25 (SNS2) - D54-1 (GND1) Microphone connection detection signal Always Below 1 V
D56-26 (CSLD) - Body ground Shield ground Always Below 1 Ω
D56-27 (CGND) - Body ground Camera ground Always Below 1 Ω
D56-28 (V+) - D56-29 (V-) Video signal Ignition switch ON, Shift position in R Camera lens not covered, displaying image Pulse generation (Refer to waveform 1)
Ignition switch ON, Shift position in R Camera lens covered, blacking out screen Pulse generation (Refer to waveform 2)
D56-29 (V-) - Body ground Video signal ground Always Below 1 Ω
D56-30 (CA+) - Body ground Power source Ignition switch ACC 5.5 to 7.05 V
D147-1 (USV1) Power source - -
D147-2 (US1-) Data signal - -
D147-3 (US1+) Data signal - -
D147-4 (UGD1) Ground - -
D147-5 (USG1) Shield ground - -
RA-5 (ANT+) - D54-1 (GND1) Power source of antenna Ignition switch ACC
Radio switch on and FM or AM selected
11 to 14 V

a.
E265840C04
0.823,2.073 1,2.073 1,2.073 1.125,1.583 false 1.479,2.063 1.344,2.063 1.344,2.063 1.229,1.479 false 0.781,4.167 0.958,4.167 0.958,4.167 1.156,3.594 false 1.521,4.125 1.385,4.125 1.385,4.125 1.271,3.542 false 0.229,0.229 0.542,0.427 0.313,0.198 10 *a 0.396,1.052 0.76,1.313 0.365,0.26 10 GND 0.396,3.208 0.76,3.469 0.365,0.26 10 GND 0.26,2.271 0.625,2.531 0.365,0.26 10 *b 0.646,4.073 1.01,4.333 0.365,0.26 10 *c 0.656,1.979 1.021,2.24 0.365,0.26 10 *c 1.51,1.969 1.875,2.229 0.365,0.26 10 *d 1.542,4.052 1.906,4.313 0.365,0.26 10 *d
*a Waveform 1 (camera lens not covered, displaying image)
*b Waveform 2 (camera lens covered, blacking out screen)
*c Synchronization Signal
*d Video Waveform


Reference (Oscilloscope waveform):

i.

Waveform 1 (camera lens is not covered, displaying an image)

Item Content
Measurement terminal D56-28 (V+) - D56-29 (V-)
Measurement setting 200 mV/DIV., 50 μs./DIV.
Condition Ignition switch ON, shift position in R, camera lens not covered, displaying image

HINT:
·

The video waveform changes according to the image sent by the rear television camera assembly.

·

The video waveform is constantly output when the ignition switch is ACC.




ii.

Waveform 2 (camera lens is covered, blacking out the screen)

Item Content
Measurement terminal D56-28 (V+) - D56-29 (V-)
Measurement setting 200 mV/DIV., 50 μs./DIV.
Condition Ignition switch ON, shift position in R, camera lens covered, blacking out screen

HINT:
·

The video waveform changes according to the image sent by the rear television camera assembly.

·

The video waveform is constantly output when the ignition switch is ACC.







METER MIRROR SUB-ASSEMBLY (w/ Headup Display)


Click hereVehicle Interior>METER / GAUGE / DISPLAY>HEADUP DISPLAY SYSTEM>TERMINALS OF ECU