In this circuit, the combination meter assembly receives FC system indicator signals from the EV control ECU via the CAN communication system. The combination meter assembly displays the FC system indicator based on the data received from the EV control ECU.
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
Because the order of diagnosis is important to allow correct diagnosis, make sure to begin troubleshooting using How to Proceed with Troubleshooting when CAN communication system related DTCs are output.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Check for DTCs.
No DTCs are output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Using the GTS, read the Data List.
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DATA LIST / ACTIVE TEST
| Tester Display | Measurement Item | Normal Condition | Reference Value | Diagnostic Note |
|---|---|---|---|---|
| HV/EV System Indicator | FC system indicator value | Min.: -101%, Max.: 511% or Unset | Current FC system indicator value | "Unset" is displayed when the vehicle is stopped and the ignition switch is on (READY). |
| Tester Display |
|---|
| HV/EV System Indicator |
HV/EV system indicator value displayed on the GTS is almost the same as FC system indicator indication.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the combination meter assembly.
Click hereVehicle Interior>METER / GAUGE / DISPLAY>COMBINATION METER>REMOVAL
Check that the operation of the FC system indicator returns to normal.
The operation of the FC system indicator returns to normal.
| Proceed to |
|---|
| OK |
| NG |
OK
NG