| *A | for Power Tilt and Power Telescopic Steering Column | *B | for 14 Speakers |
| *C | for 6 Speakers | - | - |
| *1 | NO. 2 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY | - | - |
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM (for Power Tilt and Power Telescopic Steering Column)
2.REMOVE MULTI-DISPLAY ASSEMBLY WITH BRACKET (for 14 Speakers)
3.REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (for 6 Speakers)
58833B
5.REMOVE UPPER NO. 1 CONSOLE PANEL GARNISH
55470
6.REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY
55606
7.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
55407C
9.REMOVE LOWER INSTRUMENT COVER SUB-ASSEMBLY
|
|
|
Remove in this Direction | - | - |
Remove the clip of the No. 2 instrument panel safety pad sub-assembly in the range as shown in the illustration.
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Detach the claw and guide.
Detach the clip and remove the lower instrument cover sub-assembly.
83100
10.REMOVE COMBINATION METER ASSEMBLY
Remove the 4 screws.
Detach the guide and pull out the combination meter assembly.
Disconnect 2 connectors.
Using needle-nose pliers, detach the clamp and remove the combination meter assembly.