Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM
RM37H0E _56 Audio / Visual / Telematics _095293 PARK ASSIST / MONITORING _0455114 BLIND SPOT MONITOR SYSTEM C

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  U1331  Software Incompatibility with Body Control Module "B"  


DESCRIPTION

This DTC is stored when the destination information of the main body ECU (multiplex network body ECU) does not match that of the blind spot monitor sensors.

Blind Spot Monitor Master
DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority
U1331 Software Incompatibility with Body Control Module "B" Destination information of the main body ECU and blind spot monitor sensor do not match
·

Main body ECU (multiplex network body ECU)

·

Blind spot monitor sensor RH


Blind Spot Monitor Master A

Blind Spot Monitor Slave
DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority
U1331 Software Incompatibility with Body Control Module "B" Destination information of the main body ECU and blind spot monitor sensor do not match
·

Main body ECU (multiplex network body ECU)

·

Blind spot monitor sensor LH


Blind Spot Monitor Slave A

CAUTION / NOTICE / HINT

NOTICE:
·

When checking for DTCs, make sure that the blind spot monitor system is turned on.

·

Before replacing the main body ECU (multiplex network body ECU), refer to the Registration.



PROCEDURE

1.CONFIRM PART NUMBER (MAIN BODY ECU [MULTIPLEX NETWORK BODY ECU])
a.

Check the main body ECU (multiplex network body ECU) part number.

i.

Check if the part number of the main body ECU (multiplex network body ECU) installed to the vehicle is correct.

OK:

The part number is correct.




Result:
Proceed to
OK
NG



OK

2.CHECK FOR DTC

NG

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

2.CHECK FOR DTC
a.

Check for DTCs.

Body Electrical > Blind Spot Monitor Master > Trouble Codes
50001 313

Result:
Result Proceed to
U1331 is not output A
U1331 is output B



A

3.CHECK FOR DTC

B

3.CHECK FOR DTC
a.

Check for DTCs.

Body Electrical > Blind Spot Monitor Slave > Trouble Codes
50001 314

Result:
Result Proceed to
U1331 is not output A
U1331 is output B



A

B