| *A | for Manual Tilt and Manual Telescopic Steering Column | *B | for Power Tilt and Power Telescopic Steering Column |
Use the same procedure for the RH and LH sides.
The procedure listed below is for the RH side.
1. CHANGE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM SETTINGS (for Power Tilt and Power Telescopic Steering Column)
45287
2.REMOVE LOWER STEERING COLUMN COVER
|
|
Turn the steering wheel assembly to the right and remove the screw.
Turn the steering wheel assembly to the left and remove the screw.
Remove the screw.
|
Push in this Direction | - | - |
Push the lower steering column cover sub-assembly and disengage the 2 claws as shown in the illustration.
Disengage the 2 claws to remove the lower steering column cover sub-assembly.
Remove the lower steering column cover in the direction of the arrow shown in the illustration.
Do not damage the tilt and telescopic switch and felt.
45286B
3.REMOVE UPPER STEERING COLUMN COVER
|
Remove in this Direction | - | - |
Disengage the claw.
Detach the claws to remove the upper steering column cover.
84650
4.REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY
|
Remove in this Direction |
|
Protective Tape |
Using a screwdriver with its tip wrapped with protective tape, disengage the claw and remove the windshield wiper switch assembly as shown in the illustration.
If the claw is pulled with excessive force, it may break.